Related Manuals for NAIM FLATCAP 2
Summary of Contents for NAIM FLATCAP 2
- Page 1 W O R L D C L A S S H I F I O W N E R S M A N U A L I S S U E 1 power supplies: Supercap, Hi-cap, Flatcap 2, NAPSC...
-
Page 2: Table Of Contents
3.5 if you have a problem 1 Equipment Installation 4 Warnings Normally your Naim equipment will have been installed by the dealer who sold it to you 5 Connection 5.1 mains lead even if you live outside their immediate vicinity. Your dealer is responsible for making 5.2 non-rewireable mains... -
Page 3: Mains Supply
In most territories a dealer must be prepared to take back improve system performance. any Naim equipment he has sold you if he cannot make it work to your satisfaction in your own home. A problem may Do not wire voltage dependent resistors or noise be due to a fault in any part of the system or its suppressors into mains plugs. -
Page 4: Connection
Use of non-standard speaker cables or interconnects may correct replacement must be obtained from your dealer, or invalidate your guarantee. from Naim Audio direct. Do not use the plug until the fuse carrier is replaced. 5.4 plug fuses Replace only with ASTA or BS 1362 approved fuses. -
Page 5: Power Supply Rear Panels
2, 3, 4, 6 Note ch 2 The Flatcap 2 features various technologies to reduce microphonic effects, in particular a compliant mounting for the main circuit boards and the DIN sockets on the rear. Some movement of the board and sockets when connecting/disconnecting is normal. -
Page 6: Nac 252 Connection To
Note Extra Supercap, Hi-cap or Flatcap 2 for SNAXO or IXO5. Supercap - socket 5, Hi-cap - socket 3, Flatcap 2 - socket 2. Hi-cap mains input to SNAXO or IXO5 Interconnect Cables... -
Page 7: Nac 282 Connection To Supercap
NAC 282 connection to Supercap NAC 282 NAPSC mains input to stereo power amplifiers Supercap mains input to mono or dual mono power amplifiers or with extra Supercap for SNAXO Supercap mains input to SNAXO Interconnect Cables cable direction 4 to 4 pin DIN marker 240°... -
Page 8: Nac 282 Connection To
Hi-cap mains input mains to mono or dual mono input power amplifiers or with extra Flatcap 2 or Hi-cap for SNAXO or IXO5 Flatcap 2 for CD5, headline or stageline to SNAXO or IXO5 (using power mains input external power supply) -
Page 9: Nac 202 Connection To Hi-Cap And Napsc
NAC 112 Flatcap 2 for CD5, Headline or power Stageline (additional) mains input interconnects required or with extra Flatcap 2 for SNAXO or IXO5 Flatcap 2 for CD5, Headline or Stageline (additional) power mains input to SNAXO or IXO5 interconnects required... -
Page 10: Flatcap 2
Flatcap 2 70 x 432 x 301mm NAPSC 57 x 121 x 187mm Declaration of conformity to appropriate standards Manufacturer Naim Audio Limited, Southampton Road, Salisbury, England, SP1 2LN Products Supercap, Hi-cap, Flatcap 2, NAPSC Safety HD 195-S6 EN 60 065... - Page 11 Naim Audio Limited, Southampton Road, Salisbury, England SP1 2LN Part No. OWMPS 12-001-0042 Telephone: +44 (0) 1722 332266 Fax: +44 (0) 1722 412034 www.naim-audio.com Drg No. NA301002-400...