Pyle PSTND35 User Manual

PSTND35
START HERE
Heavy Duty Telescoping Height Adjustment
Monitor Speaker Stand (Pair)
SCAN ME
PyleUSA.com
Questions or Comments?
We are here to help!
Phone: 1.718.535.1800
PyleUSA.com/ContactUs
www.PyleUSA.com
USER GUIDE
ASSEMBLING:
1. Take one long hex bolt and one washer and
insert through hole in center of one triangular
base on side with rubber feet.
2. Thread the long hex bolt into the bottom of
one vertical shaft and tighten hex bolt with the
provided allen wrench to secure vertical shaft to
triangular base.
3. Unthread and remove short hex bolt with
washer located in the top of the verical shaft.
4. Insert short hex bolt with washer through hole in
the center of one monitor plate and thread into top
of the vetrtical shaft with the allen wrench.
5. Adjust monitor plate height by loosening large
thumb knob on clutch housing and move upper shaft
to desired height.
6. Insert safety pin all the way through vertical shaft
at lowest hole exposed, allowing the safety pin to rest
on clutch housing. Secure by tightening large thumb
knob knob on clutch housing.
7. When placing stand on carpet, remove the rubber
feet from triangular base and screw in three leveling
carpet spikes. Adjust carpet spikes so that the monitor
platform is level.
8. Repeat steps 1 thru 7 for second stand.
This product can expose you to a chemical or group of chemicals, which
may include "Lead and Cadmium" which is known in the state of
California to cause cancer, birth defects, or other reproductive harm.
For more info, go to https://www.p65warnings.ca.gov/.
ENG