Pyle PSTNDW18 User Manual

PSTNDW18
Dual Universal Adjustable Wall Mount Speaker Bracket Stands
with Angle, Tilt, Rotation Adjustment (Pair)
At upright 90° position, you can
mount a 22" deep speaker cabinet.
90° (degrees)
Installation Instructions:
Required Tools: socket or hand wrench, drill, drill bit, stud nder, pencil, level,
tape measure, (4) 3/8" x 4" lag bolts
Step #1: Remove brackets from box.
Step #2: Check for stud location with a stud nder and place speaker bracket in
desired location.
Step #3: Test that the bracket plate is level and mark the hole locations on the
wall using the holes from bracket backer plate as a template.
Step #4: Drill proper mounting hole (smaller than outer thread diameter of your lag bolts) through wall into
wood studs or concrete block. Hole depth should be properly drilled so that your lag bolt can go through the
sheet rock and 2" into the stud.
Step #5: Place speaker bracket on wall and install 3/8" lag bolts (recommended) in the upper location. Securing
tightly until the head of the lag bolt is rmly against the bracket. Repeat for bottom location.
Step #6: Before placing the speaker cabinet on the bracket, test installation by con rming the bracket will hold
the weight of your speaker. If desired, tilt the angle of the bracket downward to the desired angle and tighten
the bolts to lock in place.
Step #7: Place the speaker on the cabinet by inserting the vertical sleeve into the speaker cabinet's internal
adapter. Be sure the speaker is secure before releasing it. Test installation with speaker in vertical and tilted
positions to be sure the bracket stays rmly against the wall.
www.PyleUSA.com
Adjustable tilt feature allows you to mount a 30" speaker cabinet
At 30° tilt down position, you can
mount a 30" deep speaker cabinet.
30° (degrees)
2"
1/2" Sheet Rock