StreamLight FIRE VULCAN LED Operating Instructions

OPERATING INSTRUCTIONS FOR THE STREAMLIGHT FIRE VULCAN
IMPORTANT: FULLY CHARGE BEFORE FIRST USE.
Thank you for selecting the Fire Vulcan
maintenance of this product will provide years of dependable service. Please read this manual
before using your Fire Vulcan
SAVE THESE INSTRUCTIONS. This guide contains important safety and operating instructions
for your Fire Vulcan LED.
®
LED SAFETY
LED RADIATION (RG-2); DO NOT STARE INTO BEAM. MAY BE HARMFUL TO
EYES. PER IEC 62471 Ed 1.0:2006-07.
PRODUCT SAFETY
EXPLOSION RISK, BURN, AND FIRE HAZARD. BATTERIES MUST ONLY BE
CHANGED IN AN AREA KNOWN TO BE NONHAZARDOUS. SUBSTITUTION OF
COMPONENTS MAY IMPAIR INTRINSIC SAFETY. REMOVE FLASHLIGHT FROM SERVICE IF
ANY PART OF THE ENCLOSURE IS MISSING OR BROKEN.
The Fire Vulcan® LED is suitable for use in:
Class I, Div. 2 Groups A, B, C, D
Class II, Div. 2 Groups F & G
Class III Temp. Code T4
BATTERY SAFETY
EXPLOSION RISK, BURN, AND FIRE HAZARD. DO NOT DISASSEMBLE,
CRUSH, SHORT CIRCUIT, HEAT ABOVE 140°F (60°C), OR DISCARD IN FIRE. USE ONLY
WITH THE SPECIFIED STREAMLIGHT PRODUCTS. KEEP AWAY FROM CHILDREN.
BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY.
Use only battery #44610.
The rechargeable battery contained in this product is recyclable. At the end of the useful life,
under various country and state laws, it may be illegal to dispose of this battery in the municipal
solid waste stream. Check with your local solid waste officials for details in your area for recycling
options or proper disposal (In USA: RBRC).
GENERAL OPERATION
The Fire Vulcan ® LED three-position multi-mode switch is located below the
carrying handle. The lantern is factory programmed to operate in the startup
configuration. Push the switch left or right momentarily to turn "ON". Push again
for "OFF". When the lantern is "ON", the switch may be pushed in either direction for "OFF".
Alternate Mode Selection
There are four available combinations in the left switch position and four additional in the
right. The left combinations produce steady (always on) light, while the right combinations
produce blinking combinations. To select a different mode other than the startup
configurations, push switch left or right (depending on mode desired) and hold for ten
seconds to advance the mode. The Fire Vulcan
operating modes; release the switch at the desired combination.
® LED. As with any professional tool, reasonable care and
® LED.
® LED will step through the different
® LED