StreamLight VULCAN Operating Instructions

®
Operating
Instructions
®
OPERATING INSTRUCTIONS FOR STREAMLIGHT VULCAN
SAFETY
A.Before using your Vulcan and charger read all instructions in this manual and
all cautionary markings on the unit.
B. : Never leave your Vulcan with its lamp face against any surface,
WARNING
including skin, while in operation. The resultant heat build-up can cause a
fire or burns.
C. : Careful observation of the LED's serves as an important warning
IMPORTANT
of possible charge circuit malfunction, which may cause battery overcharg-
ing, the green LED should turn "on" steadily and the red LED should turn off
completely within twelve (12) hours of charging time. If the red LED stays on
past this time remove the light from service and return it immediately to the
Streamlight factory at 30 Eagleville Road, Eagleville, PA 19403 for free
evaluation and repair. In extremely rare circumstances an overcharged bat-
tery may release a flammable hydrogen gas mixture. In the unlikely event
that this mixture should ignite, bodily harm could result.
D.The Vulcan should not be switched on and off during charging unless only the
green LED is lighted. Recycle the battery responsibly when no longer service-
able. DO NOT INCINERATE THE BATTERY, EVEN IF IT IS SEVERELY DAM-
AGED OR COMPLETELY WORN OUT. The battery could explode in a fire.
Handle the battery carefully and never allow it to short circuit. A shorted bat-
tery can easily start a fire.
E. The Vulcan is approved for use in hazardous locations. You are responsible
for the proper application of this product in a properly defined location.
DO NOT charge in potentially hazardous areas.
OPERATION
The Vulcan is available in two (2) basic models: the single filament and the dual
filament safety back-up model. Both come with convenient recharging racks,
either AC/DC or vehicle mount that store light conveniently and do not require
Vulcan disassembly for charging. The battery is rated at a nominal 4.5 ampere-
hours and is capable of being recharged up to 500 times.
To release the light from the rack push the black bar down, slide the light for-
ward and lift up. The on/off switch is underneath the handle. Turn it in either
direction for "on" or in the dual filament model, rotation of the switch to the right
®