Original Instructions Forward Please read this manual carefully and make a full understanding before operating. Due to t h e limited pages we cannot answer 1 the questions but this manu can help you avoid unnecessary mistakes during operating the new machines.Please pay speci attention to the"Warning"...
Installation a.1nstall the compressor in a vent ated place. b.The space between the compressor and the w 1 should be at least 50cm. c.1nstallation of Motor: If you buy the motor yourself , please buy the same model as the ai compressor 2.1nst 1 the as shown in the following diagram: 3.Adjust the belt to a proper degree of tightness in the way of pressing the middle of the belt t...
Page 4
compressor will be frayed and the axle head will be destroyed f too high it may cause the lube to spray and the loan of the compressor to increase. Highest level Lowest level Fig.1 b.The ideal lube for the compressor should be in a general way high grade with antiovidant in not easy to become thick because of oxygenating, not easy to froth with lit e carbon left and high ignition poin Usually the 13#air compressor o is usd.the 19#air compressor o is used in winte...
Operation of the compressor The compressor uses an air switch to control the motor .When the pressure in the air storage tank rises to the rated maximum pressurethe air switch automatically.breaks to disconnect the power and stop the air compressor. en the pressure in the air storage tank goes down below the rated minimum pressure the air switch automatically oses and restarts the motor to dirve the co mpressor.
Page 6
3.Release the pressure of the drum and reduce the load 4.Break down of the motor 4.Sent f or maintenance Please tum on the air switch to discharge the pressure in the drum before wain tenance. Model TC1300506E Rated Voltage(V) 220-240~ Rated Frequency(Hz) Input power (kW/PH) (3.0)
Need help?
Do you have a question about the TC1300506E and is the answer not in the manual?
Questions and answers