GlassCrafters C-FM-3030 Installation Instructions

Congratulations on your purchase of Americas finest Mirrored Cabinet Accessories by GlassCrafters, Inc.
World class engineering and state of the art design will enable you to enjoy your wall mirror & cabinet for many years to
come. We realize that the marketplace offers many choices and we thank you for selecting
The following instruction sheet must be used with the Mirrored Cabinet installation instructions
To properly install your GlassCrafter Decorative Wall Mirror
you must determine the height and width of the mirror. The
following installation guide will walk you through the installa-
tion of a C-FM-3030 mirror.
Determine the height above the finished floor or sink
cabinet. ( Note: when installing with Mirrored cabinets the
cabinets require a minimum of 1" above any faucet height or
other obstruction for the door swing). Scribe a level horizon-
tal line for the base of the mirror.
Determine the width of the entire unit you are in-
stalling. Scribe a plumb center line for the position of this
unit. The sample mirror is 30" wide so you would mark the
left and right edge of the mirror 15" on either side of the cen-
terline.
Measure up 24" from the horizontal base line and
make a level horizontal line for the location of the bottom Wall
Mount Mirror Bracket (466-00).
Measure in from the marks for the left and right edge
of the mirror and mark this position. Hold the Wall Mount
Bracket on the inside of each mark and scribe the hole posi-
tion for each bracket. Drill the holes using a 3/16" masonry
bit. Insert one plastic wall anchor (#10PWA) in each hole.
Using the wall anchor screws (#10x1 1/2") Phillips Screws)
fasten each bracket to the wall. Test the fit of the mirror.
Your GlassCrafters Wall Mirror has the Single Mirror
Bracket (#465-00) pre-installed to the backside of the mirror
along with the three foam pads.
If this Wall Mirror is being installed with Mirrored
Cabinets follow the cabinet instructions for the order of instal-
lation.
When you are ready to install the Wall Mirror remove
the tape from the foam pads and carefully lower the mirror
onto the wall bracket to a level position. Do not let the foam
pads adhere to the wall prior to the final position of the mirror.
Check to make sure that both brackets are properly engaged
before releasing the mirror. Apply slight pressure to engage
the foam pads
Please use extreme care while unpacking and handling your GlassCrafters' Decorative Wall Mirror & Accessories.
Report any damage immediately to our GlassCrafters customer service team at 800-233-7362,
Revised 11/2014
GLASSCRAFTERS, INC
193 Veterans Blvd., Carlstadt, NJ 07072
Decorative Wall Mirror
Installation Instructions
GlassCrafters for your bath mirror and cabinet needs.
and the Center Shelf installation sheet.
Monday thru Friday from 8:00 am to 5:00 pm (EST)
1+(800) 233-7362 (F) 1+(888) 233-7362
sales@glasscraftersinc.com
Horizontal position of
Wall Brackets --
Mirror width less 5"
equally spaced on centerline
24"
Front
Back