Zeta Alarm Systems INFINITY ID2 ACTIVE REPEATER Installation Manual page 4

INFINITY ID2 ACTIVE REPEATER MANUAL
2. Overview of the Infinity ID2 Active Repeater
The Infinity ID2 active repeater is used on an Infinity ID2 Panel.
It is powered from the ID2 Panel, so is connected via 4 cores: 2 x power and 2 x data. Op to 8 repeaters can be
connected. The first 2 repeaters can be powered from the panel. Subsequent repeaters would need an external
power supply.
Each repeater can be selectively configured to determine which commands it will send to the network. EG to
allow some repeaters to reset the system, and others to not reset the system.
Each Repeater can also be configured to run in a different language (Although any device labels entered by the
installer will just be in the language entered)
The repeater shows Alarms and faults from the fire panel. It does not show disablements or test mode events.
The repeater can be configured to start panel sounders, stop panel sounders, Silence panel Buzzers and reset the
panel. The repeater can not interrogate panel configuration or device status. The repeater can not select
disablements or test mode.
3. Repeater Access Levels
The Infinity ID2 active repeater has the following access levels:-
Access Level Access
Code
AL1 N/A
AL2 123
AL3 369
Approved Document No: GLT-221-7-1
Issue 1.0 Author: NRPJ
.
Available functions
View panel indications
Silence fault buzzer
Scroll between multiple event messages
Start Alarm Sounders (Evacuate)
Stop Alarm Sounders
Reset panel
Select Repeater Panel Language
Select Panel the repeater connects to
Select Repeater Number
Configure repeater response
•
Start Sounders
•
Stop Sounders
•
Reset Panel
•
Silence All
Date: 29/11/2013
Software Versions: 0.H.8682
PAGE 4