Advertisement
Quick Links
MODEL TJFU
A X I A L J E T F A N S
Ins ta llation, Op era tion & M ain ten ance M a nua l
READ AND SAVE THESE INSTRUCTIONS
The purpose of this manual is to aid in the proper installation and operation of fans manufactured by
S&P Ventilation Systems. These instructions are intended to supplement good general practices and are
not intended to cover detailed instruction procedures, because of the wide variety and types of fans
manufactured by S&P Ventilation Systems.
S&P Ventilation Systems
SolerPalau-USA.com | SolerPalauCanada.com
TJFUIOM
Advertisement
Related Manuals for S&P TJFU
Summary of Contents for S&P TJFU
- Page 1 MODEL TJFU A X I A L J E T F A N S Ins ta llation, Op era tion & M ain ten ance M a nua l READ AND SAVE THESE INSTRUCTIONS The purpose of this manual is to aid in the proper installation and operation of fans manufactured by S&P Ventilation Systems.
-
Page 2: Installation
INTRODUCTION DO NOT INSTALL, USE OR OPERATE THIS EQUIPMENT UNTIL THIS MANUAL HAS BEEN READ AND UNDERSTOOD. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE USE. It is the responsibility of the purchaser to ensure that the installation and maintenance of this equipment is handled by qualified personnel experienced in such work and equipment. - Page 3 It is necessary to observe the fan manufacturer’s recommendations and limitation concerning the type of material to be handled by the fan and its application in special conditions. Model TJFU: Axial Fans | 2 ®...
- Page 4 WIRING 3 | SOLERPALAU-USA.COM INSTALLATION, OPERATION AND MAINTENANCE MANUAL ®...
-
Page 5: Hanging The Fan
Mechanical connections to the mounting surface and proper wiring must be performed by qualified personnel and must comply with local codes. Once all electrical connections are complete, replace cover plates as required. Ceiling Slab Jet Fan Model TJFU: Axial Fans | 4 ®... -
Page 6: Maintenance
START-UP Lock out the power source. Tighten all bolts and setscrews securely. NOTE THAT ALL BOLTS AND SETSCREWS SHOULD BE TIGHTENED AFTER TWO DAYS OF INITIAL OPERATION. Clearance should be checked all around between wheel or propeller tips and the housing before starting up. The wheel or propeller should not strike the housing. -
Page 7: Repair Parts
• Bent shaft Excessive Noise • Loose fan mounting bolts • Rattle of components in high velocity airstream • Electrical noise • Noise from high velocity air system • Vibrating parts not isolated from building Model TJFU: Axial Fans | 6 ®... -
Page 8: Limitation Of Warranty And Liability
WARRANTY S&P Ventilation Systems warrants this equipment to be free from defects in material and workmanship for five (5) years from date of shipment. Any units or parts which prove to be defective and are reported during the warranty period will be replaced at our option when returned to our factory, transportation prepaid. - Page 10 S&P USA VENTILATION SYSTEMS Enab ling the World t o Bre athe B et ter Air ® S&P USA VENTIL ATION SYSTEMS, LLC S&P CANADA VENTILATION PRODUCTS, INC. 6393 Powers Avenue 6710 Maritz Drive, Unit 7 Jacksonville, FL 32217 Mississauga, ON L5W 0A1, Canada SolerPalau-USA.com SolerPalauCanada.com 800.961.7370...
Need help?
Do you have a question about the TJFU and is the answer not in the manual?
Questions and answers