Milesight VS340 Quick Start Manual

1. Packing List
Presence Sensor
DESK & SEAT OCCUPANCY SENSOR
1 x VS340 & VS341 Sensor
2 × Mounting Kits
2. Hardware Introduction
LED Indicator
PIR Sensor
4 × PIR Covers 1 × 3M Tape
Power Button
PIR Sensor
1 × Quick Start Guide 1 × Warranty Card Mounting Holes
3. Power Button and LED Patterns
NFC Area
Press and hold the power
Power On/Off
button for more than 3 seconds
PIR Cover
Check On/Off Status Quick press the power button
Thermopile Sensor
(VS341 Only)
Press and hold the power
Reset to Factory Default button for more than 10 seconds
Vacant Occupied
Occupancy Status
Mounting Holes Occupied Vacant
LED Indicator
Battery
Thermopile Sensor
(VS341 Only)
4. Configuration Guide
1. Download "Milesight ToolBox"App on an NFC-supported smartphone.
Power On Off On
Power Off On Off
Light On Device is on.
Light Off: Device is off.
Android
Blinks quickly
2. Open "Milesight ToolBox" App and attach the NFC area of the smartphone to device, click "NFC
Read" to read/write the device until the App successfully shows a prompt. It's suggested to
Blinks twice change the default password for security reasons. (Default password: 123456)
Blinks twice
iOS