OROSYS Two Notes Torpedo Reload II User Manual page 11

2025/02/19 18:22
A/B: Select for use with a TRS footswitch. Here, the switch connected to "Tip" will control the
On/Off state of CHANNEL A and the switch connected to "Ring" will control the On/Off state of
Channel B
A+B : Select for use with a TS footswitch. Here the Switch connected to "Tip" will control the
On/Off state of both CHANNELS
19. AMP IN: Connect your Amplifier's Speaker Output to this input; ensure a Speaker Cable is used
for this connection and Reload II's AMP IMPEDANCE (20) Selector is set to the correct impedance
rating for your amplifier's output
20. AMP IMPEDANCE: Use this selector to match the impedance of your amplifier to the internal
load in Reload II
21. CAB OUT: Use these outputs to send source signals assigned to CHANNEL A or CHANNEL B to
traditional guitar/bass cabinets
2.1 Warning Indicators
Torpedo Reload II Includes the following warning indicators located on the rear panel of the device:
General Fault Warning Indicator (top LED indicator)
The General Fault Warning Indicator is triggered by a fault in Torpedo Reload II's integrated
Poweramp. When triggered the Poweramp will enter protection mode, deactivating the amplifier and
the resultant sound output from the device. The root causes triggering the General Fault Warning
Indicator stem from a number of sources; as such, it is advised that you contact
Team to review remedial strategies pertaining to your rig setup and connectivity requirements.
Temperature Warning Indicator (bottom LED indicator)
User's manuals - https://wiki.two-notes.com/
11/26 Torpedo Reload II User's Manual
Two notes' Support