OROSYS Two Notes Torpedo Reload II User Manual page 10

Last update: 2025/02/19 15:44
clipping for either CHANNEL A or CHANNEL B
7. OUTPUT: Independent knobs on CHANNEL A or CHANNEL B to set the LINE OUT (12) level for the
related CHANNEL
8. DEPTH: Emphasises the low-end frequency content of the source audio for the related channel
9. PRESENCE: Emphasises the high-end frequency content of the source audio for the related
CHANNEL
10. MOJO CONTROLS: Engage to deliver high-power feel, even at low-volume
2. Rear Panel Control & Connectors
11. LINE IN: Connect ¼-inch TS or TRS Line Level sources (including Preamps, Modellers, Amp Sims
and more) to either LINE IN A and/or LINE IN B to feed CHANNEL A or CHANNEL B respectively
12. LINE OUT: Connect the XLR LINE OUT A or LINE OUT B to interfaces, mixers or similar to send a
balanced feed of the selected CHANNEL SOURCE (4) for CHANNEL A and CHANNEL B respectively
13. LOOP LEVEL: Independent switches for CHANNEL A's and CHANNEL B's FX LOOP offering -10dBV
or +4dBu operation
Top Tip: Use the +4dBu option for line level FX devices; use the -10dBV option for guitar level
devices (i.e. pedal format delays)
14. DRY WET MIX (Knob & Switch): Configure whether DRY/WET MIX operation is active per
CHANNEL using the independent ON/OFF switches; adjust the balance between the DRY SOURCE
signal and effected WET signal using the DRY/WET knob for either CHANNEL A or CHANNEL B
15. DUAL MONO / LINK A>B: Use this selector to determine the RETURN routing behaviour of
Reload II's FX Loop; In DUAL MONO mode, each RETURN is configured independently in mono, feeding
the respective CHANNEL corresponding to the RETURN; In LINK A>B MODE, the signal connected to
RETURN A is replicated on RETURN B, irrespective of any source connected to RETURN B.
16. SEND: Low impedance FX SEND ¼-inch TS jack for use with external effects processors including
PEDALS, Multi FX Devices or similar
17. RETURN: High impedance FX RETURN ¼-inch TS jack for receipt of signals from the outputs of FX
PEDALS, Multi FX Devices or similar
18. FOOTSWITCH A+B / A/B: Set the behaviour of Reload II's Footswitch input in line with either TS
or TRS equipped footswitches:
https://wiki.two-notes.com/
reloadii:reloadii_user_s_manual https://wiki.two-notes.com/doku.php?id=reloadii:reloadii_user_s_manual
Printed on 2025/02/19 18:22