OROSYS Two Notes Torpedo Reload II Manual

Warnings & Setup Considerations
Always ensure the impedance rating of your amplifier's speaker output is matched to
the AMP IMPEDANCE setting on Reload II; failure to ensure a correct match may result in
irreversible damage to your amplifier or loadbox.
Always connect the speaker out of your tube amplifier to an appropriate load (speaker
cabinet or loadbox). Reload II, once powered, is such a load. Always power on Reload II
before your amplifier. The maximum admissible power of Reload II is 200W RMS.
Always use a Speaker Cable for connections between the amplifier's speaker out and
Reload II's AMP IN. Always use a Speaker Cable for connections between Reload II's CAB
OUT A/B outputs and any connected cabinets. Using an Instrument Cable instead of a
Speaker Cable can cause significant damage to your amplifier or Reload II, ultimately
requiring service by a qualified technician. If unsure about the classification of your
cabling, please seek advice from a qualified specialist.
Only connect traditional guitar or bass cabinets to Reload II's CAB OUT A/B connectors;
for active speaker connections please use Reload II's LINE OUT A/B XLR ports.
Setting your amplifier's master volume to maximum may result in irreversible damage to
your amplifier or loadbox. The fact that the volume control of your amplifier is not set at
maximum does not mean your amplifier is not running at maximum volume - as such, we
advise setting the output of the companion amplifier to a volume configuration you
would use in a rehearsal or on stage.
The correct use of an amplifier with a loadbox requires a degree of precaution. When
testing the amplifier at high volume, monitor the color of the tubes and the general state
of the amplifier. Red-glowing tubes or any appearance of smoke are signs of a problem
that may result in partial or complete destruction of the amplifier.
When playing an amplifier connected to Reload II at high volume, you may hear some
noise stemming from Reload II. This is perfectly normal. This sound is produced when
power from the amplifier transmits through the coil of the reactive load embedded in
the Torpedo Reload II.
Reload II's CLIP indicators on CHANNEL A or CHANNEL B light up red whenever the signal
is too strong at the related CAB output. If present, please lower the volume with the
corresponding CAB knob.
+33 (0)4 84 25 09 10 - support@two-notes.com - www.two-notes.com
Manufactured and Imported by
OROSYS S.A.S. - Two notes Audio Engineering
76 rue de la Mine, 34980 Saint-Gély-du-Fesc FR
Thanks for choosing
Multi-Impedance Reactive Load Box & Active Attenuator
Introducing Torpedo Reload II. The latest instalment in Two notes'
class-leading reactive load solution legacy marking the definitive
watershed in contemporary backline control.
Featuring twin-channel operation, selectable multi-impedance
compatibility and true continuous attenuation, Reload II is our most
advanced Load Box to date. Its mission is simple: unleash the power
of any amplifier or line-level source without compromise.
Armed with a ground-up rework of our defining reactive load for a
Celestion® Approved Load Response, the match is set to drive any
amp's power-stage (rated up-to 200W RMS) to perfection, retaining
all the sonic integrity your performance demands.
Scalable from a whisper to a full-throttle onslaught, Reload II's ultra-
transparent dual-mono 215W (per channel) amplifier/attenuator
and paired speaker outputs preserve every facet of your tone.
Add a Stereo FX Loop, twin DI outputs and GENOME Reload II Edition
(software download) into the mix and Reload II doesn't just enhance
your rig, it redefines it.
Register your Unit
register.two-notes.com
Reload II User Guide
reloadmanual.two-notes.com