Advertisement

Quick Links

KEGB9305L
EN
Dishwasher
User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KEGB9305L and is the answer not in the manual?

Questions and answers

Summary of Contents for Electrolux KEGB9305L

  • Page 1 KEGB9305L Dishwasher User Manual...
  • Page 2: Table Of Contents

    14. ENVIRONMENTAL CONCERNS..............29 WE’RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. You’ve chosen a product that brings with it decades of professional experience and innovation. Ingenious and stylish, it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time.
  • Page 3: Safety Information

    ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
  • Page 4: Safety Instructions

    (average) domestic usage levels. Do not change the specification of this appliance. • The operating water pressure (minimum and • maximum) must be between 0.5 (0.05) / 10 (1) bar (MPa) Follow the maximum number of 15 place settings.
  • Page 5: Water Connection

    ENGLISH • Warning: this appliance is designed to be installed / connected to a grounding connection in the building. • Make sure that the parameters on the rating plate are compatible with the electrical ratings of the mains power supply. •...
  • Page 6: Installation

    Refer to Safety chapters. 3.1 Building in min. 550 www.youtube.com/electrolux www.youtube.com/aeg How to install your AEG/Electrolux 60 cm Sliding Door Dishwasher 3.2 Safety caps If the furniture panel is not installed, open the appliance door carefully to avoid the risk of injury.
  • Page 7: Product Description

    ENGLISH functionality of the appliance and may cause an injury. If the plastic cover is damaged, contact the Authorized Service Centre to replace it with the new one. 5 mm 4. PRODUCT DESCRIPTION Ceiling spray arm Upper spray arm...
  • Page 8: Internal Light

    Lower spray arm Detergent dispenser Filters Lower basket Rating plate Upper basket Salt container Cutlery drawer Air vent Rinse aid dispenser 4.1 Beam-on-Floor 4.2 Internal light The Beam-on-Floor is a light that is The appliance has an internal lamp. It...
  • Page 9: Programme Selection

    ENGLISH 5.1 Display 5.2 ECOMETER The ECOMETER indicates how the programme selection impacts energy and water consumption. The more bars are on, the lower the consumption is. indicates the most environmentally friendly programme A. ECOMETER selection for a normally soiled B.
  • Page 10: Glass Care

    65 and 70 °C for at This is the standard programme for least 10 minutes during the last rinsing phase. test institutes. 6.2 AUTO Sense ExtraPower The AUTO Sense programme ExtraPower improves the...
  • Page 11: Consumption Values

    ENGLISH Pro‐ Dishwash‐ Degree of Programme phases EXTRAS gramme er load soil 2h 40min Crockery, Normal to • Prewash • ExtraPower cutlery, heavy, • Dishwashing 60 °C • GlassCare pots, pans dried-on • Intermediate rinse • ExtraHygiene • Final rinse 60 °C •...
  • Page 12: Information For Test Institutes

    In your request, include the product Information for test institutes number code (PNC) from the rating plate. To receive the necessary information for For any other questions regarding your conducting performance tests (e.g. dishwasher, refer to the service book according to: EN60436 ), send an email provided with your appliance.
  • Page 13: How To Enter Setting Mode

    ENGLISH Use Previous and Next to switch • The current setting value flashes. between the basic settings and to 3. Press Previous or Next to change change their value. the value. 4. Press OK to confirm the setting. Use OK to enter the selected setting and •...
  • Page 14: The Rinse Aid Level

    German de‐ French de‐ mmol/l mg/l (ppm) Clarke Water soften‐ grees (°dH) grees (°fH) degrees er level 4 - 10 7 - 18 0.7 - 1.8 70 - 184 5 - 12 <4 <7 <0.7 <70 < 5 1) Factory setting.
  • Page 15: Key Tones

    ENGLISH automatically released during the hot The duration of the drying phase and the rinse phase. It is possible to set the door opening time vary depending on the released quantity of rinse aid. selected programme and options. When rinse aid chamber is empty, the When AirDry opens the door, the display rinse aid indicator is on notifying to refill shows the remaining time of the running...
  • Page 16: How To Fill The Rinse Aid Dispenser

    Do not use 6. Turn the cap of the salt container detergent and do not put dishes in clockwise to close the salt container. the baskets. CAUTION! After starting the programme, the Water and salt can come out...
  • Page 17: Daily Use

    ENGLISH 9. DAILY USE 1. Open the water tap. The upper ends of the two 2. Press and hold until the appliance vertical ribs inside the is activated. compartment (B) indicate 3. Fill the salt container if it is empty. the maximum level for filling 4.
  • Page 18: How To Delay The Start Of A Programme

    • The ECOMETER indicates the When the countdown is complete, the updated level of energy and water programme starts. consumption. 9.7 How to cancel the delay By default, options must be start while the countdown activated every time before operates you start a programme.
  • Page 19: End Of The Programme

    ENGLISH 9.10 The Auto Off function 9.11 End of the programme This function saves energy by switching When the programme is complete, the the appliance off when it is not operating. display shows 0:00. The function comes into operation The Auto Off function switches the automatically: appliance off automatically.
  • Page 20: What To Do If You Want To Stop Using Multi-Tablets

    10.5 Loading the baskets • Make sure that the water softener level is correct. If the level is too high, • Always use the whole space of the the increased quantity of salt in the baskets. water might result in rust on cutlery.
  • Page 21: How To Start The Machine Care Programme

    ENGLISH 11.1 Machine Care 11.3 Removal of foreign objects Machine Care is a programme designed Check the filters and the sump after each to clean the appliance interior with use of the dishwasher. Foreign objects optimal results. It removes limescale and (e.g.
  • Page 22: Cleaning The Lower Spray Arm

    7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A).
  • Page 23: Cleaning The Upper Spray Arm

    ENGLISH 2. To detach the spray arm from the basket, press the spray arm upwards and simultaneously turn it clockwise. 2. Wash the spray arm under running water. Use a thin pointed tool, e.g. a toothpick, to remove particles of soil 3.
  • Page 24: Troubleshooting

    11.8 Cleaning the ceiling spray 2. Move the upper basket to the lowest level to reach the spray arm more easily. 3. To detach the spray arm (C) from the We recommend to clean the ceiling spray delivery tube (A), turn the mounting...
  • Page 25 ENGLISH Problem and alarm code Possible cause and solution You cannot activate the • Make sure that the mains plug is connected to the appliance. mains socket. • Make sure that there is no damaged fuse in the fuse box. The programme does not •...
  • Page 26 Problem and alarm code Possible cause and solution The level of water inside • Switch the appliance off and on. the appliance is too high. • Make sure that the filters are clean. The display shows iF1. • Make sure that the outlet hose is installed at the right height above the floor.
  • Page 27 ENGLISH Once you have checked the appliance, The PNC can be found on the rating deactivate and activate the appliance. If plate on the appliance door. You can the problem occurs again, contact an also check the PNC on the control panel. Authorised Service Centre.
  • Page 28 Problem Possible cause and solution There are stains and dry wa‐ • The released quantity of rinse aid is not sufficient. ter drops on glasses and Adjust the rinse aid dosage to a higher level. dishes. • The quality of the rinse aid can be the cause.
  • Page 29: Technical Information

    ENGLISH Refer to "Before first use", "Daily use", or "Hints and tips" for other possible causes. 13. TECHNICAL INFORMATION Dimensions Width / height / depth (mm) 596 / 818 - 898 / 550 Voltage (V) 220 - 240 Electrical connection Frequency (Hz) Water supply pressure Min.
  • Page 32 www.electrolux.com/shop...

Table of Contents