Jabra Engage 65 Mono Faq

Jabra Engage 65 Mono
How do I connect my Jabra Engage with my Nortel IP 1120E,
1140E, 1150E, 1165E desk phone so I have remote call control
using my headset?
Prerequisites
Jabra Link 14201-32 Electronic Hook Switch (EHS) cable
One of the following Nortel IP phones: 1120E, 1140E, 1150E, 1165E
Connect your headset
1. Connect the USB plug of the Jabra EHS adapter to the USB port of
your desk phone.
2. Connect the 2-sided end of the Jabra EHS adapter to the Jabra base
by plugging the RJ10 (small) plug into the port marked with a phone
icon and the RJ45 (wide) plug into the base port marked AUX.
Configure your headset when connecting to a desk phone for the first
time
For Jabra Engage 75/75 SE, follow the onscreen setup wizard on the
base.
For Jabra Engage 45 SE/65/65 SE, the initial setup is complete after
connecting the cables.
Additional setup information for your Jabra products
EHS cable/adapter type: DHSG.
Clear dial tone switch: set to position "A".
We recommend setting the microphone volume to "7" out of 13.
https://www.jabra.com/en-au/supportpages/jabra-engage-65/9553-553-
117/faq/1fbb9a27-73f3-49c0-8496-ef9e57110e1b
24/10/2024 22:34
Page 1 of 2