Selecting The Bluetooth Device; Setting A Voice Command - Kenwood KDC-X395 Instruction Manual

"PAIRING" is displayed (KDC-X395/
7
KDC-348U with KCA-BT300 only)
If "PAIRING OK" is displayed, proceed to
step 10.
If "PIN CODE NG" is displayed, proceed to
steps 8.
Input the PIN code
8
■ Turn the volume knob to select the number.
To move to the next digit, press ¢.
■
To delete the last digit, press 4.
■
Press the volume knob to transmit the
9
PIN code.
If "PAIRING OK" is displayed, registration is
completed. If the error message appears
even though the PIN code is correct, try
Registering Special Bluetooth device.
10 Hold to finish the procedure.
■
To exit Bluetooth mode, press
■
If there are 5 or more Bluetooth devices
registered, you cannot register a new
Bluetooth device.
Registering Special Bluetooth device
/
1
KDC-BT648U KDC-X695
Press to enter Bluetooth mode.
/
KDC-X395 KDC-348U
Press and hold the volume knob to enter
Bluetooth mode.
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to select
3
[PAIRING], then press to enter.
Turn the volume knob to select [S-DVC
4
SELECT], then press to enter.
Turn the volume knob to select a device
5
name, press to confirm.
Go through the procedure step 4
6
of <Registering from this unit> and
complete the registration (pairing).
■
If the device name is not in the list, select
"OTHER PHONE".

Selecting the Bluetooth Device

/
1
KDC-BT648U KDC-X695
Press to enter Bluetooth mode.
/
KDC-X395 KDC-348U
Press and hold the volume knob to enter
20
English
Bluetooth mode.
Turn the volume knob to select
2
[SETTINGS], then press to enter.
3 Turn the volume knob to select
[PAIRING], then press to enter.
4 Turn the volume knob to select [PHONE
SELECT] or [AUDIO SELECT], then press
to enter.
Turn the volume knob to select a
5
Bluetooth device name.
Press the volume knob to set up the
6
Bluetooth device.
■
■
■
SRC.
■
Hold
7
■ To exit Bluetooth mode, press

Setting a Voice Command

Registering Phone Book Name
1
KDC-BT648U
Press
KDC-X395
Press and hold the volume knob to enter
Bluetooth mode.
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to select [VOICE
3
TAG], then press to enter.
4 Turn the volume knob to select [PB
NAME EDIT], then press to enter.
5 Search for the Phone Book name to
register
Select the name to register with reference
to 5 in <Calling a Number in the Phone
Book> (page 16).
If a voice tag has already been registered
for a name, "*" is displayed before the
name.
Turn the volume knob to select [PB
6
NAME REG], then press to enter.
"✱(Device name)": The selected Bluetooth
device is busy.
"-(Device name)": The selected Bluetooth
device is on standby.
" (Device name)": The Bluetooth device is
deselected.
If a cell-phone is already selected,
deselect it, and then select a different
one.
to finish the procedure.
/
KDC-X695
to enter Bluetooth mode.
/
KDC-348U
SRC.