Getting Started; Canceling The Display Demonstration; Setting The Demonstration Mode; Adjusting The Clock - Kenwood KDC-X395 Instruction Manual

Getting Started

Canceling the display
demonstration
The display demonstration is always turned
on unless you cancel it.
When you turn on the power (or after you
reset the unit), the display shows:
[CANCEL DEMO] \ [PRESS] \ [VOLUME
KNOB]
Press the volume knob.
1
[YES] is selected as the initial setup.
Press the volume knob again to confirm.
2
[DEMO OFF] appears.
■
If no operation is done for about 15 seconds
or if you turn the volume knob to select
[NO] in step 2, [DEMO MODE] appears and
the display demonstration starts.

Setting the demonstration mode

1 Press the volume knob to enter
[FUNCTION].
Turn the volume knob to select [DEMO
2
MODE], then press to enter.
Turn the volume knob to select [ON] or
3
[OFF].
If [ON] is selected, display demonstration
starts if no operation is done for about 20
seconds.
Hold to finish the procedure.
4
Item
PRESET TYPE NORMAL *: Memorizes one station for each preset button in each band (FM1/ FM2/ FM3/ AM). ;
MIX: Memorizes one station for each preset button regardless of the selected band (FM1/ FM2/ FM3/ AM) and
another Satellite Radio Tuner.
KEY BEEP ON */ OFF: Activates/deactivates the keypress tone.
BUILT-IN AUX ON1 *: Outputs sound of the connected external component through the car speakers when "AUX" is selected as the
source. ; ON2: Outputs sound from the connected external component when "AUX" is selected as the source. When
you turn on the power, the sound attenuates (to prevent noise when no external component is connected). Turn the
volume knob clockwise to return to the previous volume level. ; OFF: Disables "AUX" in source selection.
CD READ 1*: Automatically distinguishes between audio file disc and music CD. ; 2: Forces to play as a music CD. No sound can
be heard if an audio file disc is played.
SP SELECT OFF */ 5/4/ 6 × 9/6/ OEM: Selects the speaker size for optimum performance.
F/W UP xx.xx YES: Starts upgrading the firmware. ; NO *: Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/

Adjusting the clock

Press the volume knob to enter
1
[FUNCTION] mode.
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to select [CLOCK],
3
then press to enter.
Turn the volume knob to select [CLOCK
4
ADJUST], then press to enter.
Clock hour flashes on the display.
Turn the volume knob to adjust the hour,
5
then press to enter minute adjustment.
Clock minutes flashes on the display.
6 Turn the volume knob to adjust the
minute, then press to confirm.
Press 4 / ¢ to move between the
hour and minute adjustment.
Hold
7

Initial settings before operations

Press
1
Press the volume knob to enter
2
[FUNCTION] mode.
Turn the volume knob to select [INITIAL
3
SET], then press to enter.
Turn the volume knob to make a
4
selection, then press to confirm.
See table below for selection.
Hold
5
Selectable setting (Preset: *)
to finish the procedure.
SRC to enter [STANDBY] mode.
to finish the procedure.
5
English