Installation Procedure; Acquiring Gps Signals - Kenwood DDX616 Instruction Manual

Dnx series gps navigation system, ddx series monitor with dvd receiver
Hide thumbs Also See for DDX616:
Table of Contents

Advertisement

Accessories
Installation Procedure
AWARNING
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground). you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
Do not cut out the fuse from the ignition wire (red) and the
battery wire (yellow). The power supply must be connected
to t e wires via the fuse.
1. To prevent a short circuit, remove the key from the
ignition and disconnect the
8
battery.
2. Make the proper input and output wire
connections for each unit
3. Connect the speaker wires of the wiring harness.
4. Connect the wiring harness wires in the following
order: ground. battery, ignition.
5. Connect the wiring harness connector to the unit
6. Install the unit in your car.
7. Reconnect the
8
battery.
8. Press the reset button.
9. Perform the Initial Setup. (Refer to the Instruction
Manual.)
Acquiring GPS Signals
The first time you turn on DNX SERIES, you must wait
while the system acquires satellite signals for the first
time. This process could take up to several minutes.
Make sure your vehicle is outdoors in an open
area away from tall buildings and trees for fastest
acquisition. After the system acquires satellites for the
first time, it will acquire satellites quickly each time
thereafter.
.......... 1
.......... 1
..........2
*'Accessory of DNX69601
DNX61601 DNX6020EXI
DNX6460BT
I
DDX6161
DDX6046BT
*JAccessory of DNX69601
D X61601 DNX6020EXI
DNX5160.
tThis accessory is used when
connecting an external
device to AV-IN jack on the
front panel of this unit For
how to use this accessory.
refer to the instruction
manual of this unit
.......... 1
~
.......... 1
®
.......... 1
®
®
DNX SERIES only
.......... 1
DNX SERIES only
.......... 1
..........6
After the Installation
After the installation, perform the Initial Setup by
referring to the instruction manual.
..........6
®
~
..........2
~
....
;
...
~'~-
~
.......... 1
2
I
DNX SERIES/ DDX SERIES

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents