Channel Scan; Switching Seek Mode; Category And Channel Search; Switching Display - Kenwood KCA-SR50 - Complete Sirius Satellite Radio System Instruction Manual

Operations
Channel Scan
Every receivable channel is checked for 10 seconds.
1
Start Channel Scan
Press the [AUTO] button for at least 2 seconds.
The channel scan will start.
2
Release it when the channel you want to listen
to is received
Press the [AUTO] button for at least 2 seconds.
Switching Display
When you are listening to the Sirius satellite radio,
you can switch over the display information as
follows.
For operations, see the <Switching Display>
page of the instruction manual of your control
unit.
~
~
• What is displayed may partly depend on control units to
be connected.
Information., ':
Switching Seek Mode
Sets the seeking mode.
Press the [AUTO] button.
Each time the button is pressed, the Seek mode
switches as shown below.
Channel Name
Song Title
Artist Name
Composer name
Category Name
Band & Channel Number
OIsplly ....
"Channel"I"CHANNEL"
"Preset"
I"
PRESET"
b\.
~
Normal manual seeking control.
Search in order of the channels in the
Preset memory
b\.
~
If the text, including Channel name, etc. is selected
when the channel which does not have text, including
Channel name, etc. is played, band & channel number is
displayed.
• This function cannot be used in the category and
channel search mode
Category and Channel Search
Select the category and channel you wish to listen
to.
1
Enter category and channel search mode
Press the [~II] button.
2
Select the category
II
Push the Control knob towards up or down.
II
Press the [FM] or [AM] button.
3
Select the channel
II
Push the Control knob towards right or left.
II
Press the
[~]
or
[~]
button.
Canceling
category and
channel
search mode
Press the [~II] button.
@2
You cannot operate this unit until all the Category
information is acqUired.
6
I
English
Function
of
remote control
Direct Access Tuning
Entering the channel and tuning.
1
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
2
Enter the channel
Press the number buttons.
3
Do Channel Search
Press the
[~]
or
[~]
button.
Cllnceling Direct Access Tuning
Press the [DIRECT] button on the remote
control.
~
~
If you make no button operation for 10 seconds, the
Direct Access Tuning mode is automatically canceled
If you cannot receive any signal in the input channel due
to a bad condition on radio wave or another problem,
"Acquiring Signal"! "ACQUIRING SIGNAL" appears.