If you use this for the first time, it may be
difficult to receive signals in the beginning.
In such a case, leave the SIRIUS source ON
for 3 minutes and turn it OFF and ON.
What might appear to be a malfunction in
your unit may just be the result of slight
misoperation or miswiring. Before calling
service, first check the following table for
The SIRIUS mode cannot be selected.
..... The SIRIUS connection wire is not connected.
Use the SIRIUS connection wire to connect the
control unit and the SIRIUS satellite radio tuner.
Connect the KCA-SRSO to the terminal labelled
TO CHANGER 2. See the section on <Connecting
Wires to Terminals>.
Nothing happens when the buttons are pressed.
..... The computer chip in the unit is not functioning
Press the reset button on the Control unit.
No broadcast can be received .
..... No subscription is established.
Subscribe to SIRIUS.
The following messages are displayed
when certain problems are occurring
in your system. Take the recommended
Antenna is not connected correctly.
Make sure the antenna is connected
correctly and then turn OFF
SIRIUS source or Control unit.
TUNER ERROR ITUNE ERR:
Broadcast cannot be received due to an error
in this unit.
of the SIRIUS source or
Control unit, or press the reset button of
ESN (Electronic Serial Number) is not
registered in this unit.
Consult your nearest service center.
CHK SSR :
The SIRIUS tuner is disconnected or a unit
other than the SIRIUS tuner is connected .
Check the connection to the SIRIUS tuner.