Related Manuals for FrontLine RPA061R
Summary of Contents for FrontLine RPA061R
- Page 1 SELF-RETRACTING LIFELiNE THE INSTRUCTIONS APPLIES TO THE FOLLOWING MODELS: RPA061S, RPA061R, RPA062S, RPA062R, RPA12S, RPA12R, RPA062RA, RPA091TB, RPA092TB, RPGC30, RPGC50 BKLFL 04...
- Page 2 If you have ques�ons on the use, care, or suitability of this equipment for your applica�on, contact Frontline Fall Protec�on at info@frontlinefall.com or visit us at www.frontlinefall.com. Before using this equipment, record the product iden�fica�on informa�on from the ID label in the inspec�on and maintenance log of this manual.
- Page 3 Don’t use if any part of the system appears to be damaged, or a body belt for fall arrest applica�ons. All connector gates withstand minimum loads of 3,600 lbs. Compa�ble Connec�ons: For Tie-Back Models Only Incompa�ble Connec�ons: Manual Revision Code: FRONTLINE-SRL-04 10-19-20...
-
Page 4: Inspection Frequency
SRL directly above the work level. Avoid working where your lifeline may cross or tangle with that of another worker. Never clamp, knot, or prevent the lifeline from retrac�ng or being taut. Manual Revision Code: FRONTLINE-SRL-04 10-19-20... -
Page 5: Installation
Swing Fall impact a�er fall event Next Lower Level or Obstruc�on Compa�bility of Components & Connectors: Frontline equipment is designed for use with Frontline approved components and subsystems only. Non- approved components or subsystems may jeopardize compa�bility of equipment and may affect complete system. - Page 6 Consult your doctor if there is reason to doubt your fitness to safely absorb the shock from a fall arrest. Age and fitness seriously affect a worker's ability to withstand falls. Pregnant women or minors must not use Frontline self-retrac�ng lifelines. Failure to heed this warning may result in serious injury or death. Opera�on: Prior to use, inspect the SRL as described in Inspec�on sentence.
-
Page 7: Maintenance, Servicing, And Storage
Do not use equipment that is not compa�ble. Ensure all connectors are fully closed and locked, ensure unintended disengagement cannot occur. Frontline connectors (snap hooks and carabiners) are designed to be used only as specified in each product’s user’s instruc�on. -
Page 8: Specifications
RPA092TB are 9ft(2.7m), RPA121R 12ft(3.6m), but will vary slightly with length differences in the various End Connector options. Labeling: Illustrates the SRLs labeling. All labels on the SRL must be present and fully legible. RPA061S Manual Revision Code: FRONTLINE-SRL-04 10-19-20... - Page 9 RPA062S RPA062R RPA062RA RPA091TB RPA092TB Manual Revision Code: FRONTLINE-SRL-04 10-19-20...
- Page 10 RPA121R RPGC30 RPGC50 Drawing 2. Incorrect Use of SRL Manual Revision Code: FRONTLINE-SRL-04 10-19-20...
- Page 11 Notes: (1) Failure of a worker to perform [before each use] inspec�on or failure of an inspec�on by a worker shall Manual Revision Code: FRONTLINE-SRL-04 10-19-20...
- Page 12 Lanyard End Inspect Snap hook for signs of damage, corrosion, and Connectors proper working condi�on. Where present: Swivels should rotate freely and gates should open, close, lock and unlock properly. Manual Revision Code: FRONTLINE-SRL-04 10-19-20...
- Page 13 Maintenance Performed Approved By: Approved By: Approved By: Approved By: Approved By: Approved By: Approved By: Approved By: Approved By: Approved By: Approved By: Approved By: Approved By: Approved By: Approved By: Approved By: Approved By: Manual Revision Code: FRONTLINE-SRL-04 10-19-20...
Need help?
Do you have a question about the RPA061R and is the answer not in the manual?
Questions and answers