Marport PRO User Manual page 35

3. If you need to reuse offsets from a previous configuration, click
configuration file (*.A2C).
4. About the pressure coefficients: you do not need to upload this file, the coefficients are
directly included in the application file downloaded from MASP. Note that if you replace
the pressure sensor, you need to change the sensor in MASP and upload the application
file again.
You can test the measures taken by the sensor (e.g. battery level, temperature, depth) to check
that there are no faults.
You can test the sensor in water or in air. In air, the following measures will be wrong: height,
conductivity.
1. Press command + A or click Menu
2. Go to the Monitoring page.
Testing Measures
and click User Mode > Advanced.
Speed Pro Sensors | V1 | Sensor Configuration
then select the
35