Other Uses Of The Re-Imaging Utility - Dell OptiPlex VDI Blaster Edition Manual

Other Uses of the Re-Imaging Utility

Running a Factory Reset
A factory reset on terminals can be run to bring the thin client back to the
state it was when it was first unboxed and used.
1
Follow the previous steps to open the boot menu and access the
Re-Imaging Utility. When the boot menu appears, select the named
hard disk or flash drive containing the Re-Imaging Utility and press
<Enter>.
2
Once the boot up is complete the Devon IT Re-Imaging Utility Dell
Edition Main Menu is displayed.
Use the arrow keys to select <15> Run Factory Reset and
3
press <Enter>.
4
The factory reset will begin immediately. The process may take a few
minutes to complete.
5
When the factory reset is finished, the thin client will reboot
Remove the hard disk or flash drive when prompted and press
<Enter> to reboot the terminal.
Dell OptiPlex FX130 and FX170 Re-Imaging Guide | 15