HP dx2040 - Microtower PC Utility Manual page 14

Table 5 Computer Setup—Boot (continued)
Option
F12 Boot from LAN
Prompt
Removable Device
Boot Seq.
Hard Disk Boot Seq.
Optical Drive Boot
Seq.
Network Boot Seq.
First Boot Device
Second Boot Device
Third Boot Device
Fourth Boot Device
Set Supervisor
Password
Set User Password
Security Option
BIOS Write Protection
8 Computer Setup (F10) Utility
Description
Disables/enables the F12 Boot from LAN prompt message on the logo screen.
Allows you to specify the order of attached removable devices (such as Floppy Discs or USB FDD).
The first drive in the order has priority in the boot sequence and is recognized as drive A.
Allows you to specify the order of attached hard drive devices (such as USB HDD storage or USB
flash media). The first drive in the order has priority in the boot sequence and is recognized as drive
C (if any devices are attached).
Allows you to specify the order in which attached optical drives (including USB ODD) are checked
for a bootable operating system image.
Allows you to specify the order in which network devices (including UP NIC cards) are checked for
a bootable operating system image.
Allows you to specify which devices will boot first, second, third, and fourth or to disable any of the
four:
●
Removable
● Hard Disk
●
CDROM
● Network
●
Disabled
NOTE: MS-DOS drive lettering assignments may not apply after a non-MS-DOS operating system
has started.
Allows you to establish a password to control access to Computer Setup.
Allows you to establish a password to control access to the computer. (Supervisor password must
be set before you can set a User password.)
Allows you to set the security option to Setup or System so that the password is required every time
the system boots or only when entering Computer Setup.
Disables/enables BIOS upgrading.
ENWW