HP dx2040 - Microtower PC Hardware Reference Manual page 25

Business pc microtower model
Hide thumbs Also See for dx2040 - Microtower PC:
Table of Contents

Advertisement

8.
Hold the expansion card just above the expansion socket on the system board then move the card
toward the rear of the chassis so that the bottom of the bracket on the card slides into the small
slot on the chassis. Press the card straight down into the expansion socket on the system board.
Figure 2-9
NOTE:
seats properly in the expansion card slot.
9.
While holding the expansion card bracket against the chassis, slide the slot cover lock down toward
the expansion card brackets and slot covers to secure them in place then replace the screw that
secures the slot cover lock.
10.
Connect external cables to the installed card, if needed. Connect internal cables to the system
board, if needed.
11.
Replace the computer access panel and reconnect the power cord.
NOTE:
To remove an expansion card, reverse the installation procedure. If you are removing a PCI
Express x16 card, pull the retention arm on the back of the expansion socket to release the card.
CAUTION:
cover for proper cooling of internal components during operation.
ENWW
Installing an Expansion Card
When installing an expansion card, press firmly on the card so that the whole connector
After removing an expansion card, you must replace it with a new card or expansion slot
Installing an Expansion Card
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Compaq dx2040

Table of Contents