Removing A 3.5" Drive Bezel Blank - HP dx2040 - Microtower PC Hardware Reference Manual

Removing a 3.5" Drive Bezel Blank

If the computer was not shipped with a device in the 3.5" bay, the bay will be covered by a bezel blank.
If you install a device in the 3.5" bay, you must first remove the bezel blank.
1. Remove/disengage any security devices that prohibit opening the computer.
2. Remove all removable media, such as diskettes or compact discs, from the computer.
3. Turn off the computer properly through the operating system, then turn off any external devices.
4. Disconnect the power cord from the power outlet and the computer, and disconnect any external
devices.
CAUTION:
long as the system is plugged into an active AC outlet. You must disconnect the power cord to
avoid damage to the internal components of the computer.
5. Remove the access panel and front bezel.
6. While facing the inside of the front bezel, press outward on the two retaining tabs on each side of
the bezel blank (1) and pull the bezel blank inwards to remove it (2).
Figure 2-4
NOTE: To install a 3.5" bezel blank, press the blank inward from inside the front bezel so that it snaps
into place.
12 Chapter 2 Hardware Upgrades
Regardless of the power-on state, voltage is always present on the system board as
Removing a 3.5" Bezel Blank
ENWW