Page 1
1-800-876-5520 • gardeners.com info@gardeners.com 1. Press a cap (H) into the top of each leg (B) using a mallet if necessary. The top side of each leg (B) has holes as shown below:...
Page 2
2. Lay two long boards (A) on a flat surface and align the ends. 3. Slide an aluminum leg (B) over each end - orient as shown below (flanges facing up): 4. Ensure the leg (B) is tight against the board (A) ends. Slide the wood until it is even with black cap (flush) and install ONLY 4 screws (G) as shown here to the right: 5.
Page 3
8. Secure the flat stock (D) to the boards (A) with a screw (G) in each hole as shown - 4 screws total. 9. Repeat steps 2-8 for the second long panel. 10. Slide an end panel (C) into the leg (B) and align the top boards. The pre-attached cross support (C) sits below the platform support (F) as shown below.
Page 4
13. Place the remaining long panel atop the end panels (C) aligning the boards with the channel in the legs (B). 14. Repeat step 11 to secure the second long panel to the planter box. 15. With two people, carefully rotate the planter upright and install a screw (G) in each corner as shown in step 10.
Protection Frame and Covers, 2' x 4' Protect your plants from chilly weather and pests with our Protection Frame and Covers. The kit includes a frame, greenhouse cover and insect netting. 3-Way 90º T Figure 1 Parts Included Connector A (4) 44 1/2"...
Need help?
Do you have a question about the 8593142 and is the answer not in the manual?
Questions and answers