Instructions for 2' x 8' Elevated Cedar Planter Box
Parts List
(4) 8' CEDAR BOARDS
(4) CORNERS
(2) PLATFORM SUPPORTS
(4) FLAT STOCK
(2) 2' END PANELS
(3) CROSS SUPPORTS
(4) CORNER CAPS
(66) SCREWS
FLOOR PLANKS
FABRIC LINER
Assembly is easiest with two people.
Assembly
NOTE: The CEDAR BOARDS have rough and smooth sides. The FLOOR PLANKS vary in width.
For video instructions, go to gardeners.com
1. Align the short edges of two 8' CEDAR BOARDS (rough sides facing up) and clamp or hold them firmly together.
2. Slide a CORNER onto the ends of the CEDAR BOARDS, positioning it as shown in Figure 1. The top CEDAR BOARD should
come to sit 1/8" above the top of the CORNER.
3. Making sure there is no gap between CEDAR BOARDS and that they are fully seated into the CORNER, secure with PHILLIPS
SCREWS. Leave the 2
hole from the bottom open for now.
nd
4. Repeat Steps 1-3 to attach another CORNER to the other end.
5. Take a PLATFORM SUPPORT and place the face with 4 holes against the CEDAR BOARDS as shown in Figure 1. Align the
holes on the ends with the holes you left open in Step 3 and secure with PHILLIPS SCREWS.
6. Slide 2 FLAT STOCK underneath the PLATFORM SUPPORT and align holes as shown in Figure 1. Secure the FLAT STOCK with
PHILLIPS SCREWS.
7. Repeat Steps 1-6 to assemble the other side panel.
Figure 1
8' CEDAR BOARDS
(rough faces)
CORNER
#8587631, 8596760
Tools Needed
Screw gun or drill with #2 Phillips bit
Phillips screwdriver
Rubber mallet or hammer
Tape Measure
Clamp (optional)
PLATFORM SUPPORT
FLAT STOCK
8% of our profits
Learn more at gardeners.com/
holes
go back to our communities.
FoRCE-FoR-GoOD
1-800-876-5520 • gardeners.com
info@gardeners.com
The top CEDAR
BOARD should
sit 1/8" above
the CORNER.
0481S Rev 04/2020
PLEASE
RECYCLE