Instructions For Using The Wet And Dry Vacuum Cleaner; Locking And Unlocking; Language Selection - Roborock F25 Combo User Manual

B1-2—Positioning the charging dock
B1-2-1—Place the charging dock upside
down, connect the power cord to
the socket of the charging dock,
and loop the cord inside the cord
storage slot as needed.
Note: The power cord can exit from either the right or
left cord storage slot opening.
B1-2-2—Place the charging dock on a flat,
hard floor and plug it in.
B1-2-3—Maintenance Brush
Notes:
• Do not place the charging dock in humid locations or
near any heat sources, such as bathrooms, kitchens,
and radiators.
• The maintenance brush can be placed in the groove at
the back of the charging dock.
Handheld Vacuum Cleaner
B2
B2-1—Installing the detachable suction unit
B2-1-1—Press the detachable suction unit
release button, and tilt the suction
unit backward to remove it.
B2-1-2—Insert the detachable suction unit
into the handheld vacuum cleaner
and tilt it downwards at a slight
angle until it clicks into place.
B2-2—Installing cleaning heads
Storage Stand
B3
B3-1—Put the storage stand on the floor,
and attach the charging dock to the
storage stand with either side of it
aligned with the back of the storage
stand.
B3-2—Install the baton holder onto the
storage stand. Push it until it clicks
into place.
B3-3—To remove the baton holder, press
the release button on the back and
pull the holder upwards.
B3-4—Store all parts as shown in the diagram.
Note: Before placing the handheld vacuum cleaner to
the storage stand, remove the detachable suction unit
to prevent it from falling down.
Instructions for
C
Using the Wet and
Dry Vacuum Cleaner

Language Selection

Press and hold the and
seconds to start language selection, then
press the button to change language.
To confirm your selection, stay upon your
preferred language for 10 seconds or press
the button.
10 10
Filling the Clean Tank
C1
C1-1—Grip the clean tank handle, press the
release button, and gently pull the
clean tank upwards at a slight angle.
C1-2—Open the cap of the clean tank refill
port, add tap water, and then close
the cap.
C1-3—Place the clean tank back to the
cleaner head. Push it down gently
until it clicks into place.
Notes:
• To avoid deforming the clean tank, only use cold water.
• To prevent corrosion or damage, do not use
any disinfectant and only use cleaning solutions
recommended by Roborock such as Roborock Floor
Cleaning Solution.
• To enhance cleaning performance, we recommend
adding a quarter of a bottle cap of the suggested
cleaning solution to the filled clean tank.

Locking and Unlocking

C2
Lightly step on the cleaner head and hold the
handle. Push it to lock the vacuum cleaner,
and pull it to unlock the vacuum cleaner.
C2-1—Locked
buttons for 3 C2-2—Unlocked
Starting the Vacuum Cleaner
C3
Tilt the handle backward to unlock the
vacuum cleaner, and press the
start it.
button to