ICO Kontour K3023W Installation Manual

Kontour Angle
Towel Warmer
Installation Guide
Code: K3023W
24" x 39" Hardwired
1 Rough-in Requirements
1. Your towel warmer requires 110V power. The power feed should be located in a single gang electrical box as
shown in Fig 2. Please ensure correct location of the electrical box, as this will govern your towel warmer location.
2. Wall studs or plywood backing is recommended in the wall at all bracket locations. See Fig 2 for bracket locations.
2 Installation Instructions
1. Check all items have been received. You should have the Towel Warmer and a
separate hardwire kit. Read all instructions before continuing.
2. Fix wall supports "A" to the wall using the screws provided and in locations as shown
on figure 2.
3. Hang and adjust the Towel Warmer using set screws "B" to lock stud "C" in the wall
bracket "A". Ensure the Towel Warmer is firmly and safely fixed.
3 Hardwire Connection
TURN OFF POWER SUPPLY BEFORE PROCEEDING
Do not connect the Towel Warmer to the power supply until all instructions have been read and installation carried out in
accord with them. Your towel warmer is 165W (110V) and conforms to CSA standards (File ref: 2422531). Please
ensure the CSA label is visible.
1. Feed the electrical cord located at the bottom of the Towel Warmer first through the round tube and then through the
cover plate.
2. Complete all electrical connections as shown in figure 3.
3. Screw tube into the towel warmer threaded collar.
4. Push cover plate onto tube and screw to electric box with the enclosed screws. Adjust where necessary.
Warning: In case of damage or failure of the Towel Warmer the unit should be returned to the manufacturer or their
distributor. The warranty of 2 years on the Towel Warmer is NOT VALID in case of improper use or installation. Product is
designed for use within Canada and the United States only.
1-877-757-8930
(see figure 3)
(see figure 1)
(see figure 4)
fig. 1
A
C
B
www.kontour.ca