Compaq BL10e - HP ProLiant - 512 MB RAM Supported Configurations page 17

If the server has a Smart Array 642, Smart Array 641, Smart Array 5304, Smart Array 5302,
4.
Smart Array 531, Smart Array 5i, Smart Array 431, or Integrated Smart Array Controller installed
as the boot controller, configure these arrays by accessing the Option ROM Configuration for
Arrays utility via the F8 key during boot. Once the configuration is complete, exit the utility to
continue the boot process.
Note:
Alternatively, you may set your array controller as the
secondary controller and install the OS to a SCSI controller.
Once the OS is installed, configure the array through the Array
Configuration Utility (ACU) using the PSP for Microsoft
Windows Server 2003 Version 7.30A
Insert the Windows Server 2003 SP1 CD into the CD-ROM drive to begin installation.
5.
After Windows Server 2003 SP1 has been installed, install the Simple Network Management
6.
Protocol (SNMP), if you want to use the functionality of the ProLiant Management Agents.
Select the Control Panel from the Start menu.
•
• Select Add/Remove Programs.
Click Add/Remove Windows Components.
•
Select Management and Monitoring Tools from the list of components.
•
• Click Details.
Select Simple Network Management Protocol so that a checkmark is displayed in the
•
checkbox.
• Click OK and then click Next.
Click Finish.
•
Install Version 7.30A (or later) of the ProLiant Support Pack (PSP) for Microsoft Windows Server
7.
2003, which is available at
http://h18023.www1.hp.com/support/files/server/us/locate/3376.html. The PSP contains
numerous files. For the PSP to be installed properly, all files must be present in the same directory
as the SETUP.EXE program.
Primary installation method
Run the SETUP.EXE program included with the PSP. By default, all software components are
•
selected for installation. In most circumstances, this default selection should not be altered.
Click Install to proceed with the installation. Although all software components are selected
•
for installation by default, only those required by the server will install. After the installation is
complete, the utility will display successfully installed components, non-applicable
components, and any component installation failures.
Command prompt installation
• Use the SETUPC.EXE to install the PSP from a command line prompt without user interaction.
This utility is designed as a tool that can be scripted. As with the SETUP.EXE program, all
components appropriate for the target server will be installed.
For additional usage information, refer to the BPXXXXXX.TXT file included with the
•
downloaded files and the ProLiant Support Pack and Deployment Utilities User Guide posted
on the download Web page for the PSP.
17