Ddr-2 - Compaq BL10e - HP ProLiant - 512 MB RAM Overview

DDR-1 DIMMs
DDR-1 DIMMs require 184 pins instead of the 168 pins used by standard SDRAM DIMMs. DDR-1 is
versatile enough for use in desktop PCs or servers. To vary the cost of DDR-1 DIMMs for these
different markets, memory manufacturers provide unbuffered and registered versions. Unbuffered
DDR-1 DIMMs place the load of all the DDR modules on the system memory bus. They can be used in
systems that do not require high memory capacity. Registered DDR-1 DIMMs (Figure 12) place only
one load per DIMM on the memory bus, regardless of how many SDRAM devices are on the module.
Therefore, they are best suited for servers with very high memory capacities.
Figure 12. DRR-1 Registered DIMM with 184-pin interface
Backward compatibility
Because of their different data strobes, voltage levels, and signaling technologies, it is not possible to
mix SDRAM and DDR-1 DIMMS within the same memory subsystem.

DDR-2

DDR-2 SDRAM is the second generation of DDR SDRAM. It offers data rates of up to 6.4 GB/s, lower
power consumption, and improvements in packaging. At 400 MHz and 800 Mb/s, DDR-2 increases
memory bandwidth to 6.4 GB/s—800 percent more than original SDRAM. DDR-2 SDRAM achieves
this higher level of performance and lower power consumption through faster clocks, 1.8-V operation
and signaling, and simplification of the command set. The 240-pin connector on DDR-2 is needed to
accommodate differential strobes signals (Figure 13).
Figure 13. DDR-2 DIMM with 240-pin interface
17