Settings Relating To The Network; Setting The Group Id And Unit Id Of The Menu Panel; Authenticating Ip Addresses Automatically; Configuring The Nfs Server - Sony MVS-8000X User Manual

Settings Relating to the
Network
Devices connected to the switcher system LAN are
automatically authenticated and listed on the display.
Setting the Group ID and Unit ID of
the Menu Panel
1
In the Engineering Setup >System >Network Config
menu (7311), press [Group ID].
2
Enter the group ID number (1 to 8) using the numeric
keypad, then press [Enter].
3
Perform the following operations.
To set the group ID only: Check the message, then
press [Yes] to exit the settings.
To set the unit ID: Check the message, then press
[No] and proceed to step 4.
4
Press [Unit ID].
5
Enter the unit ID number (1 to 4) using the numeric
keypad, then press [Enter].
6
Check the message, then press [Yes].
Authenticating IP Addresses
Automatically
1
In the Engineering Setup >System >Network Config
menu (7311), press [Auto Config].
2
Check the message, then press [Yes].
Devices that support connection with the same group
ID within the network are detected and displayed in
list view.
3
To register the list of detected devices as the setting
values at power-on, press [Define].
4
Check the message, then press [Yes].

Configuring the NFS Server

Set the address of the NFS server to use.
1
In the Engineering Setup >System >Network Config
menu (7311), press [NFS Server].
2
Enter the server address using the keyboard window,
then press [Enter].
The NFS server address is displayed in the "NFS
Server Address" field.
3
To register the setting as a power-ON default, press
[Define].
4
Check the message, then press [Yes].
Enabling the NFS server
In the Engineering Setup >System >Network Config menu
(7311), press [NFS Mount], turning it on.
The configured NFS server is mounted, ready for use.
Note
Resetting the menu panel will disable the NFS server.
To use an NFS server after resetting the menu panel,
enable the server again.
406