Subscribe to Our Youtube Channel
Related Manuals for Sentera Controls SIGWM
Summary of Contents for Sentera Controls SIGWM
- Page 1 SIGWM SENTERA WI-FI INTERNET GATEWAY FOR SURFACE MOUNTING Mounting and operating instructions...
-
Page 2: Table Of Contents
TECHNICAL DATA STANDARDS WIRING AND CONNECTIONS MOUNTING & OPERATING INSTRUCTIONS IN STEPS VERIFICATION OF INSTALLATION INSTRUCTIONS TROUBLESHOOTING TRANSPORT AND STORAGE WARRANTY AND RESTRICTIONS MAINTENANCE MIW-SIGWM-EN-000 - 10 / 03 / 2025 2 - 8 www.sentera.eu back to the table of contents... -
Page 3: Safety And Precautions
If there are questions that are not answered, contact your technical support or consult a professional. MIW-SIGWM-EN-000 - 10 / 03 / 2025 3 - 8 www.sentera.eu... -
Page 4: Product Description
FOR SURFACE MOUNTING PRODUCT DESCRIPTION The SIGWM is an internet gateway, designed to connect Sentera devices, either individually or as a network to the Internet for configuration and monitoring through SenteraWeb. It establishes a wireless connection with an existing Wi-Fi network. The unit has two Modbus RTU channels: ►... -
Page 5: Wiring And Connections
Modbus RTU communication, signal /B Pin 6 Pin 7 Ground, supply voltage Pin 8 8 mm 8 mm 8 mm 8 mm 24 VDC MIW-SIGWM-EN-000 - 10 / 03 / 2025 5 - 8 www.sentera.eu back to the table of contents... -
Page 6: Mounting & Operating Instructions In Steps
3 and 4 on the PROG header in order to restart the supply voltage. After that, the gateway will enter bootloader mode. For more information, please, refer to Fig. 4 PROG Header. MIW-SIGWM-EN-000 - 10 / 03 / 2025 6 - 8 www.sentera.eu... -
Page 7: Verification Of Installation Instructions
Green LED2 slowly blinking indicates that bootloader mode has been entered. ■ Slowly blinking red LED3 indicates system error (connection to the Cloud has been lost). MIW-SIGWM-EN-000 - 10 / 03 / 2025 7 - 8 www.sentera.eu back to the table of contents... -
Page 8: Troubleshooting
In case of heavy pollution, clean with a non-aggressive product. In these circumstances the unit should be disconnected from the supply. Pay attention that no fluids enter the unit. Only reconnect it to the supply when it is completely dry. MIW-SIGWM-EN-000 - 10 / 03 / 2025 8 - 8 www.sentera.eu...
Need help?
Do you have a question about the SIGWM and is the answer not in the manual?
Questions and answers