Installing The Power Supply - Dell PowerEdge T110 Hardware Owner's Manual

Figure 3-19. Removing the Power Supply
1
4
1 power supply
3 cable clip

Installing the Power Supply

1 Attach the cable clip to the new power supply.
2 Align the power supply mounting holes with the mounting holes on the
back panel.
3 Slide the power supply toward the back panel until it snaps into place over
the power-supply release tab.
4 Using a #2 Phillips screwdriver, install the four screws that secure the
power supply to the back panel.
5 Secure the I/O panel and SATA cables (if present) to the routing clip on
the side of the power supply.
6 Connect all the power cables to the system board and drives.
7 Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 74.
94
Installing System Components
3
2 screws (4)
4 power-supply release tab
2