Bobtot EP20T Manual

What's in the box

Buttons Overview

Button Function

Button	Function	Operation
	Power on/off	Long press
	Volume up	Short press
	Next song	Long press
	Next FM Station	Long press
	Volume down	Short press
	Previous song	Long press
	Previous FM Station	Long press
	Play/Pause	Short press
	Disconnect BT	Long press
	BT/USB/AUX/FM	Short press
	Light show	Short press
	Turn off the light	Long press
	Indoor & Outdoor Mode	Short press

How to use the speaker

Wireless Pairing

1. Long press the "POWER" button to enter BT pairing mode.
2. Find "Bobtot EP20T" speaker on the BT list of your phone or tablet, and click to connect.
3. It's successfully connected to your smart device if you hear prompt sound, and the indicator light is solid blue.

AUX/USB

Plug AUX or USB flash drive into the speaker, it will automatically play.
When using one of the connection ways, please make sure the other source is disconnected.

FM

1. Plug the 3.5mm Audio cable into the speaker, just straighten the other end, it's as an external antenna and improve signal.
2. Press the "" button on the speaker to enter FM radio mode.
3. Long press the "" button to automatically search out all the FM radio stations that can be received.

How to use the wireless microphone

Notes: Two microphones are sync when making some adjustments.

Specifications

Reset your device to factory setting

If the speaker does not work properly, you may reset it by inserting needle to AUX jack to press and hold the button for approximately 2 seconds until the speaker powers off, and then powers on again.

Safety Instructions

1. Avoid dropping.
2. Do not disassemble.
3. Avoid extreme temperatures.
4. Use original or certified cables.
5. Do not use any corrosive cleaner/oil to clean.
6. Do not use the device outdoors during thunderstorms.
7. Do not expose batteries to high heat as direct sun light, fire and Etc.