Bobtot SoundAir Manual

What's in the box

Buttons Overview

Button Function

Button	Function	Operation
	Power on/off	Long press
	TWS pairing/disconnect	Double press
	Play/Pause	Short press
	Disconnect BT	Long press
	Accept an incoming call (calling mode)	Short press
	Reject an incoming call (calling mode)	Long press
	Call back (calling mode)	Double press
	Switch between phone or speaker calls(calling mode)	Long press
	Decrease the volume	Short press
	Previous track	Long press
	Increase the volume	Short press
	Next track	Long press

Initial Setup

1. Once your speaker is fully charged, long press Power button until you hear prompt sound, which means that speaker enters BT pairing mode.
2. Find "Bobtot SoundAir" speaker on the BT list of your phone or tablet, and click to connect.
3. It's successfully connected to your device if you hear prompt sound, and mode indicator is solid blue.

Note:

1. When you power on the speaker but no connection, it will automatically shut down after 10 minutes.
2. When you connect the speaker but no playback, it will automatically shut down after 20 minutes.

True Wireless Stereo Pairing

1. Long press on two speakers to power on and blue indicator start flashing.
2. Quickly double-click on any speaker, and you will hear prompt sound indicating that speaker enter pairing mode, the indicator of one speaker turned solid blue.
3. Find "Bobtot SoundAir" speaker on the BT list of your phone or tablet, and click to connect.
4. Speaker is successfully connect to your smart device when indicators of both speakers are solid blue.

Note:

1. In TWS Mode, turn off one of the speakers, both of them are off.
2. Double-click the button will be disconnected.

Indicator Status

	Blue light flash	BT/TWS pairing
	Stay blue light	BT/TWS connected
	Red light flash	Low battery
	Stay red light	Charging
	Red light off	Full charged

Reset Function

1. Press and hold down the Power button for 8 seconds till the speaker's off.
2. The speaker has now been reset and you can turn it on.

Specifications

Safety Instructions

1. Avoid dropping.
2. Do not disassemble.
3. Avoid extreme temperatures.
4. Use original or certified cables.
5. Do not use any corrosive cleaner/oil to clean.
6. Do not use the device outdoors during thunderstorms.
7. Do not expose batteries to high heat as direct sun light, fire and Etc.