Bobtot ET310C Manual

What's in the box

Buttons Overview

Button Function

Button	Function	Operation
	Turn on/off speaker	Long press
	Increase the volume	Short press
	Decrease the volume	Short press
	Previous track	Short press
	Next track	Short press
	Play/Pause music	Short press
	Disconnect/Reconnect BT	Long press
	Mic volume	Short press
	Switch BT-AUX-USB-TF	Long press
	TWS pairing/disconnect TWS	Double press
	Outdoor & Indoor mode	Short press
	KTV/Vocal/Karaoke	Long press

Charging Your Device

Wireless Pairing

Power on speaker while indicator is flashing blue, go to wireless setting on your device, find "Bobtot ET310C" select to pair.
NOTE:

1. Speaker automatically shuts down after 10 minutes if it does not connect any device.
2. Speaker automatically shuts down after 20 minutes if it connects to device but does not play anything.

True Wireless Stereo (TWS)

1. Turn on the two speakers and disconnect the BT connection.
2. Double press on one of speakers, and you will hear prompt sound indicating that speaker enter pairing mode. Two speakers are successfully paired when indicator of one speaker is solid purple, and another is flashing purple.
3. Search for "Bobtot ET310C" on the BT list of your phone or tablet, and click to connect.

NOTE:

1. In TWS mode, if you turn off one speaker, another speaker will be turned off.
2. Double press will disconnect two speakers.

Multi-function button

AUX/USB/Memory card
Plug AUX or USB flash drive or Memory card into the speaker, it will automatically play. when using one of the connection ways, please make sure the other source disconnected.

Microphone Function
After plug the microphone into the speaker, Short press "M" to adjust microphone volume +/- Long press "EQ" to choose the microphone mode like Karaoke/Vocal/KTV.

Indicator Status

Charging Out

Reset your device to factory setting

If your speaker is not operating properly, you may reset it. To do so use a small object - such as a paper clip - to press the button inside the AUX jack. Press and hold the button for approximately 2 seconds until the speaker powers off, and then power it on again as usual.

Specifications

Safety Instructions

1. Avoid dropping.
2. Do not disassemble.
3. Avoid extreme temperatures.
4. Use original or certified cables.
5. Do not use any corrosive cleaner/oil to clean.
6. Do not use the device outdoors during thunderstorms.
7. Do not expose batteries to high heat as direct sun light, fire and Etc.