Table of Contents
Advertisement
2.9
Installing a Serial ATA disk drive
The system supports one Serial ATA hard disk drive.
To install a Serial ATA hard disk drive:
1.
Connect the SATA power cable
to the plug of the power supply
unit.
2.
Connect the SATA signal cable
and the power plugs to the
connectors at the back of the
drive.
3.
Locate the HDD tray.
4.
Insert a hard disk drive (with
the HDD PCB facing the top of
the chassis) to the tray, then
secure it with four screws.
5.
Connect the SATA signal cable
to the SATA connector on the
motherboard, and tighten all the
cables with the plastic coils.
2-16
2
1
4
4
4
4
4
Chapter 2: Basic installation
Advertisement
Table of Contents
