4.4
Connectors
1.
Serial ATA connectors (9-pin SATA1, SATA2)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
•
Only Windows
above support Serial ATA hard disk drives.
When using the connectors in Standard IDE mode, connect the primary (boot)
•
hard disk drive to the SATA1 or SATA2 connector.
2.
COM port connector (10-1pin COM1)
This connector is for a serial (COM) port. Connect the serial port module
cable to this connector, then install the module to a slot opening at the back
of the system chassis.
ASUS P2-M2A690G
2000 Service Pack 4 / Windows
®
XP Service Pack1 and
®
4-5