Messages - Panasonic DMP-BDT320 Owner's Manual

Messages

The following messages or service numbers
appear on the television or unit's display.
On the television
Cannot play.
You inserted an incompatible disc (Discs
recorded in PAL video, etc.).
Cannot display on this unit.
You tried to play a non-compatible image.
Confirm "SD" on the unit's display is not
displayed and re-insert the card.
No disc inserted.
The disc may be upside down.
$ This operation is not available.
Some operations are unsupported by the unit.
For example;
– BD-Video: During playback, reverse
slow-motion or reverse frame-by-frame is
not possible.
IP address is not set.
The "IP Address" in "IP Address/DNS
Settings" is "---. ---. ---. ---". Set the "IP
Address", "Subnet Mask", and "Default
Gateway". (Select the automatic address
acquisition if necessary.)
The current wireless network security setting
is weak. It is recommended to change to a
stronger security setting.
Authentication type for the wireless LAN is set
to "Open system", or the encryption type is
set to "No encryption". It is recommended to
encrypt for safety reasons. For details, refer
to the instructions of the wireless router being
used. Encryption is required when playing
back video, etc., from DLNA compatible
devices.
36 VQT3V22
On the unit's display
F99
The unit fails to operate properly. Press [Í/I]
on the main unit for 3 seconds to switch the
unit to standby, then switch back on.
HDMI ONLY
Some BD-Video discs can only be output with
HDMI.
NET
While connecting to a network.
No PLAY
There is a viewing restriction on a BD-Video
or DVD-Video. (
No READ
The media is dirty or badly scratched. The
unit cannot play.
PLEASE WAIT
The unit is carrying out an internal process.
This is not a malfunction. You cannot operate
the unit while "PLEASE WAIT" is displayed.
REMOVE
The USB device is drawing too much power.
Remove the USB device.
SET (" " stands for a number.)
The remote control and main unit are using
different codes. Change the code on the
remote control.
Press and hold [OPTION] and the following
button at the same time for more than
5 seconds depending on the indication.
SET 1: [G]
SET 2: [B]
SET 3: [Y]
U59
The unit is hot.
The unit switches to standby for safety
reasons. Wait for about 30 minutes until the
message disappears.
Select a position with good ventilation when
installing the unit.
31)