Charging The Battery Pack - Memorex MVDP1078 - DVD Player - 7 User Manual

CHARGING THE BATTERY PACK

"LOW BATTERY" will appear on the screen when the battery is low and needs
recharging. The battery can be charged while attached or not attached to the unit
as follows:
WITH THE BATTERY ATTACHED TO THE UNIT:
With the Battery Pack attached (see previous page), and the unit turned off, insert the
small end of the AC adapter into the DC IN jack on the side of the unit. Insert the other
end (with the 2 blades) into a conveniently located AC outlet having 120V AC, 60Hz.
The CHARGING indicator will blink red as the battery is charging and will light solid
red when charging has completed. When you turn the unit on again, the CHARGING
indicator will turn off. Disconnect the AC adapter plugs when charging has finished.
WITH THE BATTERY NOT ATTACHED TO THE UNIT:
You can also charge the battery when it is not attached to the unit by inserting the
small end of the AC adapter into the DC IN CHARGE jack on the battery pack next
to the connector and tabs. Insert the other end (with the 2 blades) into a conveniently
located AC outlet having 120V AC, 60Hz. The CHARGE indicator will blink red as the
battery is charging and will light solid red when charging has completed. Disconnect
the AC adapter plugs when charging has finished.
NOTES:
• Fully charge the battery pack (2.5 hours) before using it for the first time. After the
initial charge, it should take approximately 2.5 hours to charge.
• A fully-charged battery can operate for about two hours.
• Charge the Battery Pack at least once every three months, even if you are not
using it.
• The Battery Pack can charge only when the unit is in the OFF mode. To turn this
unit off, simply slide the POWER ON/OFF switch to the OFF position.
POWER SOURCES (CONTINUED)
8