Related Manuals for Memorex MVDP1101
Summary of Contents for Memorex MVDP1101
- Page 1 MVDP1101 User’s Guide 10'' TFT DISPLAY PORTABLE DVD PLAYER WITH REMOTE CONTROL Before operating this product, please read these instructions completely.
-
Page 2: Table Of Contents
Contents ......1 Important Safety Instructions ..2 Precautions . -
Page 3: Important Safety Instructions
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. - Page 4 SURGE PROTECTORS: It is recommended to use a surge protector for AC connection. Lightning and power surges ARE NOT covered under warranty for this product. LASER WARNING: This unit employs a laser. Only qualified service personnel should attempt to service this device due to possible eye injury.
- Page 5 Dear Customer: Selecting fine audio equipment such as the unit you’ve just purchased is only the start of your musical enjoyment. Now it’s time to consider how you can maximize the fun and excitement your equipment offers. This manufacturer and the Electronic Industries Association’s Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level.
-
Page 6: Precautions
The top and rear panels of the DVD player may become warm after a long period of use. This is normal and not a malfunction. • When the DVD player is not in use, be sure to remove the disc and turn off the power. •... -
Page 7: To Obtain A Clear Picture
When you bring the DVD player directly from a cold place to a warm place. • When you use the DVD player in a room where you just turned on the heater, or a place where the cold wind from the air conditioner directly hits the unit. -
Page 8: Power Sources
AC CONNECTION Insert the small end of the AC adapter into the jack on the side of the unit. Insert the other end (with the 2 blades) into a conveniently located AC outlet having 120V AC, 60Hz. DO NOT insert into the DC IN CHARGE jack. -
Page 9: Charging The Battery Pack
POWER SOURCES (CONTINUED) CHARGING THE BATTERY PACK “Low Battery” will appear on the screen when the battery is low and needs recharging. The battery can be charged while attached or not attached to the unit as follows: WITH THE BATTERY ATTACHED TO THE UNIT: With the Battery Pack attached, insert the small end of the AC adapter into the DC IN CHARGE jack on the side of the Battery Pack or the DC IN jack on the side of the unit. -
Page 10: Location Of Controls
MAIN UNIT Display DC IN CHARGE Jack 9V z (Side of the Rechargeable Battery) CHARGE Indicator (Side of the Rechargeable Battery) Left Speaker DC IN Jack 9V z (Side of the Main Unit) SCREEN MENU Button - Button (for Screen Menu Adjustment) + Button (for Screen Menu Adjustment) MODE Button 10. -
Page 11: Side
SIDE 1. AUDIO OUT Jack 2. PHONE (Headphones) 2 Jack 3. PHONE (Headphones) 1 Jack 4. VOLUME Control 5. VIDEO/COAXIAL OUT Jack REMOTE 6. COMPONENT OUT (Y/Pb/Pr) Jack 7. Battery Pack 8. Battery Release Switch (Bottom of the Battery Pack) 1. -
Page 12: Remote Control
BATTERY INSTALLATION Follow these precautions when using a battery in this device: Use only the size and type of battery specified. Be sure to follow the correct polarity when installing the battery as indicated next to the battery compartment. A reversed battery may cause damage to the device. If the device is not to be used for a long period of time, remove the battery to prevent damage or injury from possible battery leakage. -
Page 13: Connection
CONNECTING THE UNIT TO A TV USING THE A/V CABLE (INCLUDED) NOTES FOR CONNECTING TO A TV: • If your TV has Component (Y, Pb, Pr) inputs, connect the unit with them for best results. • Set the TV’s TV/VIDEO button or switch to the VIDEO setting. •... -
Page 14: Connecting The Unit To A Tv Using The Component Cable
CONNECTING THE UNIT TO A TV USING THE COMPONENT CABLE (INCLUDED) NOTES FOR CONNECTING TO A TV: • TV must have Component (Y/P • Set the TV’s TV/VIDEO button or switch to the VIDEO setting. • When connecting the unit, refer to the owner’s manual of the TV, as well as this manual. -
Page 15: Progressive (Y, P ) Video Out
PROGRESSIVE (Y, P Use these jacks to connect to a TV with progressive video input jacks, press the I/P (Interlace/Progressive) button to select PROGRESSIVE SCAN. (NOTE: If you press the I/P button again, the TV mode setting will change back to INTERLACE. -
Page 16: Theater System (Audio Jack)
CONNECTING THE DVD TO A HOME THEATER SYSTEM (AUDIO JACK) Place the subwoofer, front, rear and center speakers in locations as shown/described here. After correctly positioning the speakers, perform the Tone Test on the AV Amplifier and adjust the Volume control(s) until the desired sound is achieved. -
Page 17: Theater System (Coaxial Jack)
CONNECTING THE DVD TO A HOME THEATER SYSTEM (COAXIAL JACK) Place the subwoofer, front, rear and center speakers in locations as shown/described here. After correctly positioning the speakers, perform the Tone Test on the AV Amplifier and adjust the Volume control(s) until the desired sound is achieved. -
Page 18: About Discs
It is important that you read the manual that accompanies the DVD disc, as there are features that are on the DVD player that cannot be used with certain DVDs. There are also extra features on the DVD disc that are different for each DVD disc, so they are not... - Page 19 DVD disc does not correspond to the Region number of this DVD player, this DVD player cannot play that disc. You may not be able to play back some DVD video discs on this player if they were purchased from outside your geographic area or made for business purposes.
-
Page 20: Setup Menu
The Setup menu lets you customize the DVD player by allowing you to select various language preferences, turn screen saver on and off, adjust what type of television screen you have and more. Use the following instructions to navigate and change the options as described on the upcoming pages. -
Page 21: General Setup Menu
GENERAL SETUP MENU: Press the SETUP button to enter the menu, select GENERAL SETUP using the Navigation (√,®) buttons, then press the PLAY/ENTER button to select it. Select/change the Setup option as described on page 19. TV DISPLAY General Audio Dolby - - General Setup Page - - Normal/PS... -
Page 22: Audio Setup Menu
CAPTIONS General General Audio Dolby - - General Setup Page - - TV Display Angle Mark OSD Lang Spdif Output Captions Screen Saver Closed Caption When this option is set to ON, Closed Captions will appear on the screen for the hearing impaired (if originally recorded on the DVD). -
Page 23: Dolby Setup Menu
DOLBY SETUP MENU: Press the SETUP button to enter the menu, select DOLBY SETUP using the Navigation (√,®) then press the PLAY/ENTER button to select it. buttons, described on page 19. DUAL MONO General Audio Dolby General - - Dolby Digital Setup - - Dual Mono Stereo L-Mono... -
Page 24: Video Setup Menu
VIDEO SETUP MENU: Press the SETUP button to enter the menu, select VIDEO SETUP using the Navigation (√,®) buttons, then press the PLAY/ENTER button to select it. option as described on page 19. General General Audio Dolby Video - - Video Setup Page - - Component COMPONENT TV Mode... -
Page 25: Preference Setup Menu
General General Audio Dolby PREFERENCE SETUP MENU: - - Preference Page - - English Audio Without a disc inserted, press the SETUP button to enter the menu, select PREFERENCE German Subtitle SETUP using the Navigation (√,®) buttons, then press the PLAY/ENTER button to select it. Disc Menu French Default... -
Page 26: Basic Operation
When “ ” appears while pressing a button, this means that the corresponding function cannot be performed either on the disc inserted, or MUTE BUTTON Press the MUTE button once to mute the sound; “MUTE” will appear on the screen. Press the MUTE button again to restore the sound;... -
Page 27: Display Button
DISPLAY BUTTON While playing a DVD, press the DISPLAY button to cycle as follows: 1st press: Title elapsed time 2nd press: Title remaining time 3rd press: Chapter elapsed time 4th press: Chapter remaining time 5th press: Display off I/P (INTERLACE/PROGRESSIVE) BUTTON Press this button repeatedly to select between Interlace or P-Scan (Progressive Scan). -
Page 28: Dvd Operation
It is important that you read the manual that accompanies the DVD disc as there are features that are on this DVD player that cannot be used with certain DVDs. There are also extra features that are different for each DVD disc, so they are not explained in this owner’s manual. - Page 29 Close the disc tray. After loading, the menu screen of the DVD should appear. Use the Navigation (√,®,π,†) buttons 1 to select the desired option and press the PLAY/ENTER button 2 to select it. Adjust the VOLUME control 3 as desired. NOTE: If the menu screen does not appear, press the MENU button to access it.
-
Page 30: Skip
SKIP Press the Skip (n) button 1 to advance the DVD to the beginning of the next chapter. Press the Skip (o) button 2 to move the DVD to the beginning of the current or previous chapters. SLOW MOTION Use this feature to move the DVD in slow motion. During playback, press the SLOW button 1 to move the DVD forward in slow motion speeds of 1/2, 1/4, 1/8, 1/16 and resume... -
Page 31: Title/Chapter Search
TITLE/CHAPTER SEARCH Use this feature to directly go to a specific title and/or chapter. Press the GOTO button 1 once. Press the Navigation (√,®) buttons 2 to select TITLE, then use the Number buttons 3 to select the desired title number. Playback will start immediately. -
Page 32: Repeat Playback
REPEAT PLAYBACK While playing back a DVD, this unit can repeatedly playback a chapter or title. While in the Playback mode, press the REPEAT (1-All) button once; “ appear on the screen and the currently playing Chapter will repeat continuously. Press the REPEAT (1-All) button a second time;... -
Page 33: Audio Menu
AUDIO MENU Press the AUDIO button repeatedly to change the audio language. This feature is not available on all discs. DVD MENU Press the MENU button 1, and the Main Menu of the disc will appear. Use the Navigation (√,®,π,†) buttons 2 to select the desired option, and then press the PLAY/ENTER button 3. -
Page 34: Zoom In
ZOOM IN The image on the screen can be magnified as follows: Press the ZOOM button 1 once during Normal, Slow or Still playback modes, and the unit will zoom x2. Press once or twice more and the unit will zoom x3/x4. Press yet again to resume normal view. -
Page 35: Programmed Playback
PROGRAMMED PLAYBACK The DVD player in this unit has a 20 chapter programmable memory that allows you to program up to 20 chapters on any disc for playback in any desired order. You may program 20 different chapters or you may also program certain chapters to play more than once. To... -
Page 36: Cd Operation
PLAYBACK OF A CD Press the POWER button on the remote to turn on the unit. NOTE: You can also press the POWER button on the main unit to turn on the unit. Close the disc tray. After loading, playback will start automatically. -
Page 37: Random Playback
RANDOM PLAYBACK SKIP Press the Skip (n) button 1 to advance to the beginning of the next file. Press the Skip (o) button 2 to move to the beginning of the previous file. While in the Stop mode, press the SHUFFLE button 1 once, “SHUFFLE”... -
Page 38: Selecting Tracks Using The Number Buttons
SELECTING TRACKS USING THE NUMBER BUTTONS During playback, press the Number buttons corresponding to the track number to select your desired track, and the unit will playback the desired track automatically. NOTE: Enter a three-digit number to select a track, i.e. -
Page 39: Picture Cd Operation
Press the POWER button to turn on the unit. After loading a picture CD, the pictures will automatically show as a slideshow on the screen. (If playback does not start automatically, press the PLAY/ENTER button 5 to start playback.) Press the Skip (n) 1 or (o) 2 button to select the previous or next picture. After the slideshow is done, it will stop. -
Page 40: Troubleshooting Guide
Check the following before requesting service: SYMPTOM GENERAL No power. Power on, but unit not functioning properly. No picture. No sound. Playback picture rolls. The playback picture is poor. The Search feature is not working. The picture is not fitting properly. The remote control is not working. - Page 41 CONTACT CUSTOMER SERVICE AT PLEASE KEEP ALL PACKAGING MATERIAL FOR AT LEAST 90 DAYS IN CASE YOU NEED TO RETURN THIS PRODUCT TO YOUR PLACE OF PURCHASE OR MEMOREX. FOR PARTS AND ACCESSORIES, CONTACT FOX INTERNATIONAL AT 1-800-321-6993. POSSIBLE CAUSE DVD not inserted, or inserted upside-down.
-
Page 42: Care And Maintenance
Caring for Discs • Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to come in contact with the shiny, unprinted side of the disc. • Do not attach adhesive tape, stickers, etc. to the disc label. •... -
Page 43: Specifications
Power Requirements ...DC IN 9V (Center Positive z) Battery Pack...Lithium-Polymer Rechargeable Battery DC 7.4V 4000mAh Weight ...2.7 Lbs Dimensions...(Main unit without Battery Pack) 10.3 (L) x 7.25 (W) x 1.4 (Thickness) inches Operating Temperature ...41° to 95°F Operating Humidity Range ...5% to 90% (no condensation) Accessories AC Adapter, Rechargeable Battery Pack, Remote Control, Remote Discs Played:... - Page 44 Memcorp, Inc. Weston, FL Printed in Hong Kong Visit our website at www.memorexelectronics.com...