Magtek Dynamag User Manual & Setup Manual page 3

Setup
How To Mount Your MagTek Dynamag
1. Adjust your reader to be mounted on a flat, stable surface
with four inches on either side for easy card swiping.
2. Remove the fastening adhesive from your device and clean
the surface where you want to mount it with isopropyl
alcohol.
3. Mount the Dynamag device on a flat, stable surface using
velcro or double-sided tape.
4. Run cable alongside the top of the surface.
5. When ready, push Dynamag down on either the velcro or
tape and firmly press it in place.
Note: The Dynamag can also be mounted using screws and an
electric drill.
How To Turn On/Off
Plug-and-Play Power
1. Connect the device's Micro-USB cable to MagTek Dynamag's
USB-A port. The Dynamag has no internal battery and is
instead powered by USB connectivity.
2. Plug the other end of the USB cable into your device's host
port.
3. If plugged into a Windows computer, a one-time Windows
alert will appear on your screen. This will allow you to
download drivers via Windows.
4. Upon plugging in, your LED indicator light will flash from red
to amber to green. Once the green light is displayed, you can
begin using your card to process payments.
MagTek Dynamag - Default Password
The default password for the MagTek Dynamag, DynaMAX, and
eDynamo is 000000. With the Dynamag, merchants can create a
personalized default password for their card reader.
PaymentCloud LLC. • 800-988-2215 • support@paymentcloudinc.com
MagTek Dynamag
User Manual & Setup Guide
Table of Contents
Overview
2
Setup 3
Accept Payments 4
Settings 5
Troubleshooting 7
& Tips
Rights Reserved 8
Additional Information
Spec Sheet
Shop MagTek
Dynamag
V.022025 3