Sonoff Slampher Manual

Operating Instruction

1. Install lamp base
   To avoid electric shock, please turn off the power before installing the lamp base.
   
2. Download the eWeLink APP
   
   
   
   Android™ & iOS
   
3. Power on
   After powering on, the device will enter the quick pairing mode (Touch) during the first use. The Wi-Fi LED indicator changes in a cycle of two short and one long flash and release.
   The device will exit the quick pairing mode (Touch) if not paired within 3mins. If you want to enter this mode, please long press the manual button for about 5s until the Wi-Fi LED indicator changes in a cycle of two short and one long flash and release.
   
4. Add the device
   Tap "+" and select "Quick Pairing", then operate following the prompt on the APP.
   

Compatible Pairing Mode

If you fail to enter Quick Pairing Mode (Touch), please try "Compatible Pairing Mode " to pair.

1. Long press Pairing button for 5s until the Wi-Fi LED indicator changes in a cycle of two short flashes and one long flash and release. Long press Pairing button for 5s again until the Wi-Fi LED indicator flashes quickly. Then, the device enters Compatible Pairing Mode.
2. Tap "+" and select " Compatible Pairing Mode " on APP.
   Select Wi-Fi SSID with ITEAD-****** and enter the password 12345678, and then go back to eWeLink APP and tap "Next". Be patient until pairing completes.

Specifications

Product Introduction

Wi-Fi LED indicator status instruction

Features

Remotely turn on/off the device, schedule it on/off or share it with your family to control together.

RF Remote Controller Pairing

SlampherR2 supports the remote controller with 433.92MHz frequency band to turn on/off, which is local short-range wireless control not Wi-Fi control.

Pairing Method:
Long press the configuration button for 3s until the red LED indicator flashesred once, then short press the remote control button you want to pair for successful learning.

Clearing Method:
Long press the configuration button for 5s until the red LED indicator flashesred twice, then short press the learned button corresponding to the remote controller to clear code values of all learned buttons.

Switch Network

If you need to change the network, long press the pairing button for 5s until the Wi-Fi LED indicator changes in a cycle of two short and one long flash and release, then the device enters quick pairing mode and you can pair again.

Factory Reset

Deleting the device on the eWeLink app indicates you restore it to factory setting.

Common Problems

Why my device stays "Offline"?

The newly added device needs 1 – 2mins to connect Wi-Fi and network. If it stays offline for a long time, please judge these problems by the green Wi-Fi indicator status:

1. The green Wi-Fi indicator quickly flashes once per second, which means that the switch failed to connect your Wi-Fi:
   1. Maybe you have entered a wrong Wi-Fi password.
   2. Maybe there's too much distance between the switch your router or the environment causes interference, consider getting close to the router. If failed, please add it again.
   3. The 5G Wi-Fi network is not supported and only supports the 2.4GHz wireless network.
   4. Maybe the MAC address filtering is open. Please turn it off.
      If none of the above methods solved the problem, you can open the mobile datanetwork on your phone to create a Wi-Fi hotspot, then add the device again.
2. Green indicator quickly flashes twice per second, which means your device has connected to Wi-Fi but failed to connect to the server.
   Ensure steady enough network. If double flash occurs frequently, which means you access an unsteady network, not a product problem. If thenetwork is normal, try to turn off the power to restart the switch.