Kenmore 3102 - Pro 30 in. Gas Cooktop Use And Care Manual page 9

Setting Surface Controls (cont'd)
Setting the Bridge Burner
The Bridge Burner should be used with rectangular shaped cookware. Cookware like
the cast-iron Griddle that is supplied with your cooktop is designed specifically for best
results with the Bridge Burner.
The Bridge Burner feature may be used to combine the cooking power of 2 or if
needed 3 gas surface Burners located along the left-hand side of the glass cooktop.
The left rear and left middle Burners are controlled by the left rear surface Control
Knob. In addition the left front Burner may be added to the Bridge Burner with the left
front gas Control Knob.
Operating the Bridge Burner
1. Push the left rear surface control knob in and turn counterclockwise out of
the OFF position (See Figure 2).
2. Release the knob and rotate to the LITE position (See Figure 2 & 3). Note:
All electronic surface ignitors will spark at the same time. However, only the
selected surface Burner will lite.
3. Visually check that the left rear Burner has lit.
4. Continue to rotate the gas control knob counterclockwise past the first LO
setting to the arrow marked Multi. The left center burner will lite.
5. Visually check that both the left rear and left center Burners are lit. Adjust the
flame size by turning the control knob between the second HI and LO
settings (See Figure 3).
6. Add the left front Burner if needed. Once lit, visually adjust the flame size of
the left front Burner to match the flame size of the Bridge Burner.
7. Place cooking utensil centered over the left-hand cooktop surface Burner
Grate. DO NOT cook with any of the surface control knobs in the LITE
position (The electronic ignitor will continue to spark if the knob is left in the
LITE position).
Note: If only the left rear surface Burner is needed, follow the instructions
provided below.
Figure 1
i;i:;;ilil;ii!!!i
Operating only the Left Rear Burner
1. Place cooking utensil centered over the left-rear surface Burner Grate.
2. Push the left rear surface control knob in and turn counterclockwise out
of the OFF position (See Figure 2).
3. Release the knob and rotate to the LITE position. Note: All electronic
surface ignitors will spark at the same time. However, only the left rear
Burner will ignite.
4. Visually check that the left-rear burner has lit. Adjust the flame size by
turning the control knob between the first HI and LO settings (See Figure
3). DO NOT cook with the surface control knob in the LITE position (The
electronic ignitor will continue to spark if the knob is left in the LITE
position).
Figure 3
[ 0 --"
Off Hi Lo Multi Hi Lo
Figure 2
Left Rear Burner
lite position
Rear
Burner
adjustment
area
Bridge E rner (left rear + left
center) adjustment area
Left Center Burner
lite position