FOUNTAINS.COM 5648F Setting Up

SETTING UP THE
1) Set bottom two
stone pieces in place. Set
pump in bowl and run
power cord down
through bowl and
pedestal. With help, tip
bowl and pedestal in
order to pull out end of
cord and run toward your
power supply.
2) Open the slit in
the rubber stopper, place
around the power cord
and close, then push
down into place in the
bowl's center hole.
3) Build pump and
tube assembly as shown
at right.
4) Set 7648
Pedestal over pump
assembly.
5) Insert adapter
under the 5648 Top. Pull
tube up through 7648
Pedestal and push onto
the 5648's adapter before
setting the 5648 down.
6) Fill bowls with
water. Read pump
instructions. Turn on the
pump. If it does not
immediately begin
working, there may be an
"airlock" within the
impeller chamber.
Simply unplug and plug
in a few times and it
should start. If you want
5648F
Make sure to place your fountain on a firm
area which will not settle. Note: Always
follow local electrical codes and use a
110V GFCI protected outlet. Do not let
children climb on fountain.