Num'axes CANICALM FIRST User Manual page 10

____________________________________________________________________
Activate/deactivate the CANICALM FIRST collar
Activate: as soon as the battery is in place, the collar is ready for use.
To fit the battery in the collar, proceed in the following way:
‒ Unscrew the battery cover using a coin.
‒ Insert the battery paying attention to follow polarity indicated on the collar.
‒ Retighten the battery cover using a coin. A beep sound is emitted indicating the
collar is ready for use. If you do not hear any beep sound when retightening the
battery cover, remove the battery immediately from its housing. Check the
polarity before trying again.
Deactivate: If you wish to turn Off the collar, you should remove the battery from its
housing.
To increase the battery life, we recommend you to deactivate the collar if you are
not using it for a long period.
____________________________________________________________________
Operation
After setting up the battery, the collar remains on standby for 30 seconds to allow
you time to fix the collar on your dog.
At the 1 st bark, a beep sound is emitted.
If a 2 nd bark is detected within 30 seconds, a beep sound and a low stimulation of
short duration are emitted.
If a 3 rd bark is detected within 30 seconds, a beep sound and a low stimulation of long
duration are emitted.
If a 4 th bark is detected within 30 seconds, a beep sound and a strong stimulation of
short duration are emitted.
If a 5 th bark is detected within 30 seconds, a beep sound and a strong stimulation of
long duration are emitted.
If your dog stops barking during 30 seconds, at the next bark, the collar will start its
operating cycle from the beginning (beep sound only).
After being activated 5 times in quick succession, the collar will automatically go into safety
mode for 2 minutes before restarting itself normally.
____________________________________________________________________
Replacing battery
Replace the battery as follows:
Unscrew the battery cover using a coin.
‒
Remove the old battery.
‒
Insert the new battery (Lithium 3-V CR2) paying attention to follow polarity
‒
indicated on the collar.
Retighten the battery cover using a coin. A beep sound is emitted indicating
‒
the collar is ready for use. If you do not hear any beep sound when retightening
FGIMPGUI073 – Guide d'utilisation CANICALM FIRST – Mars 2025 – ind. G - 10/32