VEVOR 0224061301 Instruction Manual
VEVOR 0224061301 Instruction Manual

VEVOR 0224061301 Instruction Manual

Truck tent

Advertisement

Technical Support and E-Warranty Certificate www.vevor.com/support
TRUCK TENT
MODEL: 0224061301
We continue to be committed to provide you tools with competitive price.
"Save Half", "Half Price" or any other similar expressions used by us only
represents an estimate of savings you might benefit from buying certain tools
with us compared to the major top brands and does not necessarily mean to cover
all categories of tools offered by us. You are kindly reminded to verify carefully
when you are placing an order with us if you are actually Saving
Half in comparison with the top major brands.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 0224061301 and is the answer not in the manual?

Questions and answers

Mary c Phillips
August 1, 2025

manual is impossible to understand. is there a u-tube instruction?

Subscribe to Our Youtube Channel

Summary of Contents for VEVOR 0224061301

  • Page 1 Technical Support and E-Warranty Certificate www.vevor.com/support TRUCK TENT MODEL: 0224061301 We continue to be committed to provide you tools with competitive price. "Save Half", "Half Price" or any other similar expressions used by us only represents an estimate of savings you might benefit from buying certain tools with us compared to the major top brands and does not necessarily mean to cover all categories of tools offered by us.
  • Page 2 This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won't inform you again if there are any technology or software updates on our product.
  • Page 3: Important Safeguards

    IMPORTANT SAFEGUARDS WARNING: Read and understand this entire manual before operating or servicing this product. Failure to follow these warnings and instructions can cause personal injury or damage to valuable property. Avoid children using the product. And this product is not a toy. Do not allow children to play.
  • Page 4: How To Store

    your vehicle is wet, it may cause damage. 10. Allow adequate ventilation inside the tent at all times. 11. Do not attempt to drive the vehicle with the tent attached. 12. To prevent carbon monoxide from entering the vehicle and tent area, do not run the engine, do not cook inside the tent, and do not use a gas heater in the tent.
  • Page 5: Part List

    PART LIST Name Picture Tent Bag Hook Tent Body Rain fly Arc shaped support pole Cross pole Iron pole Wind Rope Ground Nail - 4 -...
  • Page 6 TIPS BEFORE ASSEBMLE THIS RECREATIONAL PRODUCT REQUIRES TWO ADULTS TO ASSEMBLE. Make sure ground surface is free from debris, i.e.,rocks that could damage flooring. Unless otherwise specified all instructions will be given assuming the assembler is facing the front opening of the tent. Carefully fold out your poles, using caution to prevent snapping the shock-cording.
  • Page 7 STEP2. Flex poles into an arch and insert the four ends of the top fiber pole into the plastic connector.(Note the direction of pipe diameter) STEP3. Insert steel leg pole into corner joint at top of tent. STEP4. Insert the pin from the pin-and-ring system into the other end Of the steel leg pole.
  • Page 8 STEP5. Repeat process until all poles are in place. Clip plastic hooks From tent to all leg poles. STEP6. Thread the assembled fiber pole through the pole sleeve of rainfly.( Tip: the fiber pole on the rainfly come with two bends.) - 7 -...
  • Page 9 STEP7. Install the rainfly, prop up the side eaves with the side door poles, hook the 4 elastic tensioners to the wire ring at the bottom. STEP8. CONNECT THE VECHILE ① From inside the tent, unzip the door and mesh that faces the vehicle cargo area.
  • Page 10 ⑤ B.WITHOUTAROOFRACK Extend the long straps to the front of the vehicle.Open the hood and attach the strap hooks to the hood hinge or frame.Tighten the straps. STEP9. Secure the straps of sleeve to the vehicle wheels: A. Insert a blue screen room pole with the metal hook into the corner joint located at the top corner of the screen room.
  • Page 11 STEP10. Tighten the elastic cord of the tent sleeve. - 10 -...
  • Page 12 STEP11. Fix the nail points at the four corner of the tents and the bottom of the connecting channel, and tighten the wind rope. Installation guide for projection screen Take out the projection screen and hang it at the position marked in the red.
  • Page 13 2. Fold the tent in half according to the length of the pole bag, roll it up and fasten it into the bag with a bandage. TENT CARE TIPS 1) We highly recommend seam sealing your tent prior to camping as water may penetrate the needle holes in the fabric.
  • Page 14 Manufacturer: Shanghaimuxinmuyeyouxiangongsi Address: Shuangchenglu 803nong11hao1602A-1609shi, baoshanqu, shanghai 200000 CN. Imported to AUS: SIHAO PTY LTD. 1 ROKEVA STREETEASTWOOD NSW 2122 Australia Imported to USA: Sanven Technology Ltd. Suite 250, 9166 Anaheim Place, Rancho Cucamonga, CA 91730 YH CONSULTING LIMITED. C/O YH Consulting Limited Office 147, Centurion House, London Road, Staines-upon-Thames, Surrey, TW18 4AX E-CrossStu GmbH...
  • Page 16 Technical Support and E-Warranty Certificate www.vevor.com/support...

Table of Contents