Maintenance; Grease Filters; Active Carbon Filter - Whirlpool AKR 891 Important Safety Instructions Manual

MAINTENANCE

WARNING:

GREASE FILTERS

The metal grease filter has unlimited duration. It should be washed at least once a month, either by hand, or by placing it in the dishwasher (use a short cycle
and low temperature). If washed in the dishwasher, the grease filter surface may become matt. This will not cause any reduction of performance.
To remove the filter pull out the handle.
After the filter has been washed and dried, replace following the inverse procedure.
REPLACING THE ALOGEN LAMPS
WARNING:
1. Disconnect the hood from the electric power supply.
2. Insert the blade of a small flat screwdriver where indicated by the three points, and with a gentle
pressure lift the cover from its position.
3. Remove the faulty light bulb and replace with a new one.
4. Replace the cover (spring lock).

ACTIVE CARBON FILTER

(filter models only):
The carbon filter must be washed once a month in the dishwasher at the highest possible temperature
using a standard dishwasher detergent. It is recommended that nothing else is placed in the dishwasher
when washing the filter.
After washing, the carbon filter must be reactivated by placing it in the oven at a temperature of 100°C for
10 minutes.
Replace the carbon filter every 3 years.
Fitting the carbon filter:
1. Remove the grease filter.
2. Remove the filter holding frame by turning the "g" knobs 90°.
3. Fit the "i" carbon filter inside the filter holder "h".
To refit the filter holder and the grease filter follow the inverse procedure.
- Use safety gloves.
- Disconnect the appliance from the power supply.
- Only use 20W MAX - G4 halogen lamps.
GB4